|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 12th 04, 02:38 AM
|
|||
|
|||
T1 or T4 mains in 84mm stroker(Type 1 case)???
Question: Would it be worth it to have all T4 mains put in on a 84mm x 94mm bore new type 1 mag case? I've read that 86mm & above it would help or be needed. This is just going to be used as a hot rodding street dune buggy. Thanks guys. 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |
| 2003 Accord Leaking Transmission Case | John Horner | Honda | 1 | December 24th 04 05:16 AM |
| 96 Ford Explorer Transfer Case | krb37160 | 4x4 | 0 | December 18th 04 10:34 PM |
| Dowel lost within engine case!!! | Vaughn M Hannon | VW air cooled | 1 | October 27th 04 07:49 PM |
Linear Mode
