|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 25th 05, 01:58 AM
|
|||
|
|||
question on 1984 Door panels
My inside door panels are held on by only one fastener. What do I have to
do to get this thing tightened up? Any help would be appreciated. 
|
| Ads |
|
#2
July 25th 05, 05:34 PM
|
|||
|
|||
|
"Joe" > wrote in message
... > My inside door panels are held on by only one fastener. > What do I have to do to get this thing tightened up? Any > help would be appreciated. replace the missing fasteners. should be a few around the edge and a couple more around the inside door handle. -- "Key"
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camry::HeadLamp question | [email protected] | Technology | 3 | May 17th 05 04:02 PM |
| Good morning or good evening depending upon your location. I want to ask you the most important question of your life. Your joy or sorrow for all eternity depends upon your answer. The question is: Are you saved? It is not a question of how good | [email protected] | BMW | 0 | April 21st 05 10:01 PM |
| Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |
| JEEP question - 4.0 vs 4.0HO | James Morrow | 4x4 | 12 | June 2nd 04 05:16 PM |
Linear Mode
