If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Carb setup question.
Hi,
I just did a rebuild on my 90 YJ's carb and it was a miracle it even ran. It was blocked up pretty bad. My question is to do with the mixture screws on the front of the carb. Going all the way in and then back out, one was out 1 turn and the other was out 4 1/4 turns. I put them back to that position after I cleaned them up, but it doesn't make sense to me that they should be so different. After all the vac lines etc. are hooked up it started up, but it isn't running smoothly and I want to have a starting point as far as the screw settings before I go back at it tomorrow. Any other tips on dialing it in would be appreciated. Thanks, Dan Hoskin |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1980 LeBaron Carb | nirodac | Chrysler | 5 | November 5th 05 08:00 AM |
specific endplay question | Chronologic | VW air cooled | 2 | August 26th 05 10:23 PM |
Dizzy Question | Bugzai | VW air cooled | 6 | August 22nd 05 10:00 PM |
Holley carb Q | Brad and Mia | Ford Mustang | 7 | June 7th 05 03:10 AM |
Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |