If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1INCH body lift, troubles
my son and i put a 1 inch body lift on my 90YJ, tday, everything went
fine, everything hooked up correctly, fan shroud moved, ect,ect, Took wife to dinner, drove 5 miles, did a sharp turn in parking lot, now my power steering feels realy wierd, when i turn the wheel, it feels like a drag or binding, short drag bursts, as i turn the wheel, "stickiee" push in the clutch and it goes away,,,wierd,,, engage clutch, and its back,,,, , no noise from the pump, belt is set to correct tension, fluid level O.K. the steering-shaft, has moved down on the shaft comming out of the main-steeringwheel assembly, to the end, when i first assembled, the power steering shafts/pump, i had it all the way up, ,,it looks like its dropped an inch, , could this be binding? its tight, should i take the shaft out and spread it out an inch where the two shafts go togeather? it doesnt seem like its pulled out from there?, its dark and checked it with a flashlight, see it better tommorrow, , figured id ask before tommorrow, thanks, johnp jeepaholic |
Ads |
#2
|
|||
|
|||
I can't think of any direct link between the body lift and your reported
symptoms. You _can_ lift the driver side too high and bend some stuff where one end is mounted to the body and the other end is mounted to the frame. But you have to get pretty carried away to hurt anything. My brother and I put a body lift into his YJ, and it was easy. "Dirty Ditch Dawg" > wrote in message oups.com... > my son and i put a 1 inch body lift on my 90YJ, tday, everything went > fine, everything hooked up correctly, fan shroud moved, > ect,ect, > Took wife to dinner, drove 5 miles, did a sharp turn in parking lot, > now my power steering feels realy wierd, when i turn the wheel, it > feels like a drag or binding, short drag bursts, as i turn the wheel, > "stickiee" > push in the clutch and it goes away,,,wierd,,, > engage clutch, and its back,,,, > , > no noise from the pump, belt is set to correct tension, > fluid level O.K. the steering-shaft, has moved down on the shaft > comming out of the main-steeringwheel assembly, to the end, > when i first assembled, the power steering shafts/pump, i had it > all the way up, ,,it looks like its dropped an inch, > , > could this be binding? its tight, > should i take the shaft out and spread it out an inch where the two > shafts go togeather? it doesnt seem like its pulled out from there?, > its dark and checked it with a flashlight, see it better tommorrow, > , > figured id ask before tommorrow, > thanks, > johnp > jeepaholic > |
#3
|
|||
|
|||
I will take a wild guess and think you have a blown front axle u-joint
binding up. I am not sure why neutral would affect that other than the unloaded suspension being a slightly different angle? Oh!, maybe more likely you are in 4H because the floor has pushed up the shifter. If so I would still be checking those u-joints after adjusting the linkage right for the lift if that's it. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Dirty Ditch Dawg wrote: > > my son and i put a 1 inch body lift on my 90YJ, tday, everything went > fine, everything hooked up correctly, fan shroud moved, > ect,ect, > Took wife to dinner, drove 5 miles, did a sharp turn in parking lot, > now my power steering feels realy wierd, when i turn the wheel, it > feels like a drag or binding, short drag bursts, as i turn the wheel, > "stickiee" > push in the clutch and it goes away,,,wierd,,, > engage clutch, and its back,,,, > , > no noise from the pump, belt is set to correct tension, > fluid level O.K. the steering-shaft, has moved down on the shaft > comming out of the main-steeringwheel assembly, to the end, > when i first assembled, the power steering shafts/pump, i had it > all the way up, ,,it looks like its dropped an inch, > , > could this be binding? its tight, > should i take the shaft out and spread it out an inch where the two > shafts go togeather? it doesnt seem like its pulled out from there?, > its dark and checked it with a flashlight, see it better tommorrow, > , > figured id ask before tommorrow, > thanks, > johnp > jeepaholic |
#4
|
|||
|
|||
jacked it up this morning and put it on jack stands, ran the wheels
back and fourth, by the linkage, didnt feel any binding, loosend up the connection from the shaft to the steeringwheel assembly, the steering shaft side had alot of pull on it, tightened things back up, checked underneath on the tranny,shifter, in all gears,,no binding or hitting on any body metal, looked at all my ball-joints, and u-joints, poked prodded with a bar, no slop, dropped it off the stands, took it for a drive on the back-farm road here, doing 10mph and weaving from side to side of road, and in straight line, went int 4low and 4high, and back to 2h, did reverse, in all,,,,over bumps sharp-cornering, , ITS GONE,, , took it on the highway, drives straight and no vibes or drifting, , wierd, but ill keep looking, , and no i dont drink or do drugs,,,, , johnp |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jeep-Deere body lift question | Jeepers | Jeep | 11 | February 8th 05 05:23 AM |
1inch body lift "self-built pucks" | [email protected] | Jeep | 21 | December 9th 04 12:51 AM |
Suspension AND Body lift? | JoeArmy99 | 4x4 | 16 | June 27th 04 06:08 PM |