If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Squeezing Noise - 1991 Miata
"KWS" > wrote in
: > There are a couple of belts on my '90; I don't know about yours. > Any one can squeal. Rubber actually has a negative temperature > coefficient, which means that they get tighter as they get hot. > That's probably why the squeal goes away. It's not so easy to tell > if they are properly tightened unless you have some sort of gage. > Also, if the belt is worn, I suppose it could squeal even if it is > reasonably tight. Another cause of squeal is something binding. If one or more of the pulleys the belt turns doesn't turn freely the belt will slip. Common cause used to be the old GM long style AC compressors that got harder and harder to turn as they went bad. It was gradual and folks used to just tighten up belts to fix the problem which was a temporary fix and caused additional damage as the belts were too tight. Moral: Check the belts, if they're good and the tension is correct you're probably better off not tightening them up more, look for the problem before doing that. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FA: 1990 miata parts + much more to come - long list, many OEM &aftermarket parts for 1.6 and 1.8 liter M1's | pws | Mazda | 6 | August 2nd 05 02:53 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
Looking to buy 1991 1.8 liter turbo miata | pws | Mazda | 3 | November 23rd 04 05:37 AM |
Rear end noise on 1991 Miata. Differential? | Mike Flanagan | Mazda | 2 | September 16th 04 01:06 PM |