|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
June 7th 05, 01:38 PM
|
|||
|
|||
Jeff Strickland wrote:
> > > How do you turn the motor slowly enough to not do damage, and fast enough to > actually pump oil to the top? > > You will not cause "damage" by turning the engine over with the starter motor. I would pull out all the spark plugs and pull the fuse for (or otherwise disable) the fuel injection and then spin the engine with the starter motor until the oil pressure is raised. Give it a good 10 - 15 seconds several times waiting for the starter motor to cool between bursts. Then pop the plugs back in, re-enable the fuel injection and fire that puppy up. -Fred W 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | May 24th 05 05:27 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 6th 05 05:29 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
Threaded Mode