If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Roll Bar/brace & Shock tower brace installed
Hello, Put the roll bar /brace in yesterday. Took 3 hours and some cussing and drilling. Not real difficult.It has a rattle inside the bars when I hit a bump. I did tighten the 2 bolts that came with it. Ya think someone that built this fake rollbar put something inside as a joke? Maybe that is why it was so cheap on eBay ($85). It does help stiffen the car though and I will tighten the bolts again and if it still rattles I will drill a hole in the bottom and a small one in the top of the bars and fill it with foam. Put the front tower shock brace in today...15 Minutes, works good the whole front end feels much tighter. Only $8.50 on eBay. I also have a cold air intake kit ($25 on eBay) but not sure about putting it on. It has parts missing but what do I do with the two 2 sensors that are going in the stock filter box ? Is this set up worth the effort of installing? Any suggestion hints or advice would be appreciated. Larry Hill |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB: Shock Tower Brace | Brian Turner | Mazda | 10 | November 10th 04 09:21 PM |