If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
If it ever stops raining I'll do that... what should I be looking for?
-Mike -- A happy kid behind the wheel of a 98 Mustang GT Cold air intake FRPP 3.73 gears Steeda Tri-Ax Shifter Flowmaster 40 Series mufflers (self-installed woohoo) Hi-speed fan switch 255/60R-15 rear tires Subframe connectors Aluminum adjustable clutch quadrant "Deputy Dog" > wrote in message news:7JEDd.274$gb.94@trndny03... > Pull the plug and take a look at it. It will tell the story or at least > point you in the right direction. > > Dave > > > wrote in message > om... > >I cleaned the MAF sensor with brake parts cleaner... the wires were filthy. > > Now they are shiney silver again. I let it air dry & stuck it back in. I > > had > > the negative battery cable disconnected during all of this.. for about > > 25-30 > > minutes total. I also took off the IAC valve & it didn't have any carbon > > buildup.. so I just reconnected it without doing anything else to it. I > > also > > cleaned the IAT/ACT sensor with brake parts cleaner... couldn't really > > tell > > a difference since it's black.. but anyway... codes haven't returned yet.. > > I > > checked for codes w/ code reader anyway & no codes. The car idles far less > > rough.. and drives far less rough.. but it's still there. I've been > > tinkering with Cylinder 7 ignition wire a lot, so I'm gonna try to snag > > one > > from Tim. I'll keep you updated. > > > > -Mike > > > > -- > > A happy kid behind the wheel of a 98 Mustang GT > > Cold air intake > > FRPP 3.73 gears > > Steeda Tri-Ax Shifter > > Flowmaster 40 Series mufflers (self-installed woohoo) > > Hi-speed fan switch > > 255/60R-15 rear tires > > Subframe connectors > > Aluminum adjustable clutch quadrant > > > > > > > wrote in message > > om... > >> Check engine light JUST came on... so I immediately pulled out the code > >> reader & got: > >> > >> 0307: Cylinder 7 Misfire Detected > >> 0174: System too lean (Bank 2) > >> > >> Car stumbles/hesitates when accelerating... idles fairly rough. Any > > ideas?? > >> Thanks in advance! > >> > >> -Mike > >> > >> -- > >> A happy kid behind the wheel of a 98 Mustang GT > >> Cold air intake > >> FRPP 3.73 gears > >> Steeda Tri-Ax Shifter > >> Flowmaster 40 Series mufflers (self-installed woohoo) > >> Hi-speed fan switch > >> 255/60R-15 rear tires > >> Subframe connectors > >> Aluminum adjustable clutch quadrant > >> > >> > >> > >> > > > > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
it moved, you received, yet Martin never finally covered about the structure | Q. U. Disch | General | 0 | January 15th 05 12:21 PM |
we change them, then we finally irritate Jimmie and Candy's elder carrot | Deaf Dummy | Technology | 0 | January 14th 05 08:52 PM |
I FINALLY bought a Miata !!!! | Chief_Wiggum | Mazda | 9 | October 10th 04 05:36 AM |
Follow-up: Code 43 on 90 A. EX finally cleared! | Slipnfall | Honda | 0 | September 23rd 04 04:04 AM |