A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Ford Mustang
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Rear Seatbelt anchor points - Picture Wanted!



 
 
Thread Tools Display Modes
  #1  
Old March 13th 05, 07:05 PM
MJT
external usenet poster
 
Posts: n/a
Default Rear Seatbelt anchor points - Picture Wanted!

Howdy,

If anyone has a 65/66 convertible with rear seatbelts installed, I am trying
to find out exactly where to mount them. No holes that I can find in my 65,
and I believe that the 66 had holes factory made in the floorpan, so could
use them as a reference.

If you have them installed and could take a picture of the rear seat area
showing the mounting points, I would appreciate it greatly!

Thanks ....

Michel.


Ads
  #2  
Old March 13th 05, 09:52 PM
AGuyNamedSteve
external usenet poster
 
Posts: n/a
Default

You'll want to look for the VIN stickers on the various body panels.
That will tell you if there has likely been a repaint or potentially
body damage done to the car.

There should be stickers on the underside of the hood, inner portion of
each front fender (viewed with the hood open, in the area where the hood
seals), front nose cap (viewed with hood open), under side of each door
(viewed with door open), and underside of trunk lid. It's been several
years since I had a Mustang, so those are all the places I can think of
off-hand.

You'll look for a sticker with the VIN on it, in each of these places.
If you find that it has been either painted over or the sticker has
something like "Ford DOT," then you may want to ask more questions about
the car.

When repainting, most shops will just paint over the sticker. At best,
they may mask it off. If the entire body panel has been replaced, the
replacement panels have the "DOT" sticker.

Steve
72 Skylark Custom455

MJT wrote:
> Howdy,
>
> If anyone has a 65/66 convertible with rear seatbelts installed, I am trying
> to find out exactly where to mount them. No holes that I can find in my 65,
> and I believe that the 66 had holes factory made in the floorpan, so could
> use them as a reference.
>
> If you have them installed and could take a picture of the rear seat area
> showing the mounting points, I would appreciate it greatly!
>
> Thanks ....
>
> Michel.
>
>

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
flat towing instructions [email protected] Jeep 44 February 7th 05 07:51 AM
New *FREE* Corvette Discussion Forum JLA ENTERPRISES TECHNOLOGIES INTEGRATION Corvette 12 November 30th 04 07:36 PM
VW Golf 3 rear fog lights Joseph Meehan VW water cooled 6 October 30th 04 02:14 AM
No rear A/C in 1999 Grand Caravan Anon Dodge 4 June 5th 04 02:16 PM
Wanted to buy: 8 3/4 E body rear end in Georgia Stephen Hawking Antique cars 0 November 20th 03 01:25 AM


All times are GMT +1. The time now is 04:34 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.