If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CRX quarter window/glass gasket/moulding
88CRX DX. Does the exterior trim moulding/gasket run ALL the way
around and butt directly into the vertical piece on the would-be B- pillar? Or is there supposed to be a 1.5-2" horiz gap at the top between the vert piece and where the window trim piece starts? Both sides of mine are like this. thanks. Kevin |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Window glass not flush with moulding - 1989 Ford Probe | [email protected] | Technology | 0 | May 15th 05 06:59 AM |
ISO: window weather strip belt moulding 1981 cordoba | buddie | Chrysler | 0 | January 3rd 05 04:53 PM |
O2 GT quarter glass | Rhodes Hall | Ford Mustang | 3 | January 2nd 05 05:23 PM |
M1 Glass window withOUT a new top? | Chief_Wiggum | Mazda | 1 | October 14th 04 09:49 PM |
Window Glass | Zaphod | Saturn | 6 | May 24th 04 09:53 PM |