|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 1st 07, 07:39 PM
posted to rec.autos.makers.ford.explorer
|
|||
|
|||
2000 Explorer engine swap
I am swaping a 2004 SHOC 4.0 Explorer engine into a 2000 Explorer. I am
using the 2000 exhaust manifolds (they fit the 2004 engine) and I can not install the oil filter for the 2004 engine as it gets stuck with the exhaust manifold as it tightens... The exhaust manifolds on the 2004 engine do not fit the plumbing on the 2000 Explorer (which is 4x4)... Any suggestions on a different oil filter or oil filter relocator kit? Thanks 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Recommendations for Jeep Mechanic near Edison, NJ | [email protected] | Jeep | 1 | July 30th 06 07:10 PM |
| Further car simulator questions | Thomas Harte | Simulators | 2 | November 12th 05 01:53 AM |
| Why you should never buy a car without a tachometer | Ted B. | Driving | 112 | September 19th 05 04:09 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | January 2nd 05 05:15 AM |
Linear Mode
