If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2001 Grand Caravan - Check Engine - P1491
Check engine light came on this morning. Code that comes up is P1491 which
I believe is RAD FAN RELAY CIRCUIT. I can't find a relay labeled as such in the relay center. The RAD fan fuse checks OK. Suggestions on what and where to check would be appreciated. Thanks, JKS |
Ads |
#2
|
|||
|
|||
the fan control relay is locatd on the front bumper support behind the grill
can't miss it unplug the connector and look for corrosion in the terminals JKS wrote: > Check engine light came on this morning. Code that comes up is P1491 which > I believe is RAD FAN RELAY CIRCUIT. > > I can't find a relay labeled as such in the relay center. The RAD fan fuse > checks OK. > > Suggestions on what and where to check would be appreciated. > > Thanks, > > JKS |
#3
|
|||
|
|||
mic canic > wrote in :
> the fan control relay is locatd on the front bumper support behind > the grill can't miss it It appears to be riveted to the top of the bumper with a heatsink on top...is this right? "unplug the connector and look for corrosion in the terminals" says the man with the small hands I removed the headlamp assembly to get to it, but I can't get both of my hands in to lift the locking tab and pull at the same time. Do I need to pull the whole front off to get at this? JKS |
#4
|
|||
|
|||
"JKS" > wrote in message 7.131... > mic canic > wrote in : > > > the fan control relay is locatd on the front bumper support behind > > the grill can't miss it > > It appears to be riveted to the top of the bumper with a heatsink on > top...is this right? > > "unplug the connector and look for corrosion in the terminals" says the man > with the small hands > > I removed the headlamp assembly to get to it, but I can't get both of my > hands in to lift the locking tab and pull at the same time. Do I need to > pull the whole front off to get at this? > > JKS\ Yup thats the part in question |
#5
|
|||
|
|||
thats the critter and if you were to remove the phillips screws that hold the
center grill on it's a straight shot in to it and i use a new self tapping body bolt to hold in the new one after i have ground down the rivet with a cut off wheel some folks call me hands bear paws i couldn't play guitar because my fingers are too fat to fit the neck JKS wrote: > mic canic > wrote in : > > > the fan control relay is locatd on the front bumper support behind > > the grill can't miss it > > It appears to be riveted to the top of the bumper with a heatsink on > top...is this right? > > "unplug the connector and look for corrosion in the terminals" says the man > with the small hands > > I removed the headlamp assembly to get to it, but I can't get both of my > hands in to lift the locking tab and pull at the same time. Do I need to > pull the whole front off to get at this? > > JKS |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 6th 05 05:29 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |
rec.autos.makers.chrysler FAQ, Part 3/6 | Dr. David Zatz | Chrysler | 0 | February 18th 05 05:33 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |