|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 1st 05, 04:56 PM
|
|||
|
|||
dificult removing rear drum on 2002 neon
brake drum on 2002 dodge neon will not come off.
backed off starwheel many turns. drum is free spinning, but still won't come off. any ideas. 
|
| Ads |
|
#2
September 1st 05, 10:30 PM
|
|||
|
|||
|
hit the sides with a big rubber mallet.....shoes are hanging up inside
"normie" > wrote in message lkaboutautos.com... > brake drum on 2002 dodge neon will not come off. > backed off starwheel many turns. drum is free spinning, but still won't > come off. any ideas. >
|
|
#3
September 2nd 05, 02:29 AM
|
|||
|
|||
|
On Thu, 1 Sep 2005 15:30:50 -0600, "rob" > wrote:
>hit the sides with a big rubber mallet.....shoes are hanging up inside > > > >"normie" > wrote in message alkaboutautos.com... >> brake drum on 2002 dodge neon will not come off. >> backed off starwheel many turns. drum is free spinning, but still won't >> come off. any ideas. >> > OR-- the drum is rusted to the hub. Remove the big nut under the cap and pull the hub and rotor as one unit.
|
|
#4
September 2nd 05, 05:12 AM
|
|||
|
|||
|
what rotor?
> wrote in message ... > On Thu, 1 Sep 2005 15:30:50 -0600, "rob" > wrote: > > >hit the sides with a big rubber mallet.....shoes are hanging up inside > > > > > > > >"normie" > wrote in message > alkaboutautos.com... > >> brake drum on 2002 dodge neon will not come off. > >> backed off starwheel many turns. drum is free spinning, but still won't > >> come off. any ideas. > >> > > > OR-- the drum is rusted to the hub. Remove the big nut under the cap > and pull the hub and rotor as one unit.
|
|
#5
September 2nd 05, 10:40 AM
|
|||
|
|||
|
it went from drum to rotor, hmmmm. Anyway, Spray some penatrating oil on
the spindle of the hub and the wheel studs and hit the edge of the drum with a large hammer, it will release. Glenn beasley Chrysler Tech
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
| Clicking from rear brakes(96 Neon) | Steve Eftink | Dodge | 0 | July 5th 04 09:09 PM |
| Rear wheel lockup---2000 Neon | T. McRae | Dodge | 6 | May 8th 04 09:41 AM |
Linear Mode
