If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
camber alignment tool
What's an OK but inexpensive (around a hundred bucks or so?)
camber angle alignment tool for home use? I would assume it requires a mount and a measuring tool of the necessary accuracy & precision (is that about a tenth of a degree or so?) The mount would need to fit normal passenger vehicle wheel sizes. |
Ads |
#2
|
|||
|
|||
camber alignment tool
On Wednesday, January 27, 2021 at 11:11:56 PM UTC-5, mike wrote:
> What's an OK but inexpensive (around a hundred bucks or so?) > camber angle alignment tool for home use? > > I would assume it requires a mount and a measuring tool of the necessary > accuracy & precision (is that about a tenth of a degree or so?) > > The mount would need to fit normal passenger vehicle wheel sizes. https://www.speedwaymotors.com/Deco-...auge,2698.html 119.99 |
#3
|
|||
|
|||
camber alignment tool
On 31-01-2021 14:03 pasquale mangano > wrote:
> https://www.speedwaymotors.com/Deco-...auge,2698.html Thank you for finding that magnetic camber gauge which has a range of plus & minus 6 degrees of camber (plus 20 degree angles for caster derivations). It looks good but I worry that it says it's only for RWD vehicles. And only for cast iron hubs. Do you think the make a camber gauge that works for FWD vehicles too? And vehicles with mag wheels which likely fully cover the actual hub? On the bottom of that same page I see this $45 tool which says it's accurate to 1/8th of a degree between plus and minus 7 degrees camber. It doesn't say it's only for RWD but it does say it's a magnetic mount. Do you think these magnetic mount gauges can also work with mag wheels? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ideas for a home alignment caster/camber wheel jig to lock to 14inch to 20 inch wheel rims | Arlen G. Holder | Technology | 2 | June 12th 19 07:36 PM |
Audi Clutch Alignment tool. | Andre[_2_] | Audi | 2 | October 21st 09 03:18 AM |
Bare Tool Milwaukee 0881-20 18-Volt V18 1/4-Inch Hex Impact Driver Kit (Tool Only, no Battery) | [email protected] | Chrysler | 0 | May 22nd 09 01:17 PM |
Alignment Question: Front vs. Rear Camber | ChrisCoaster | Technology | 0 | October 24th 07 09:06 PM |
Camber Wheel Alignment on Caprice | MechTherapy | Technology | 5 | June 26th 05 05:05 AM |