If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2002 Chrysler Town & Country brake caliper guide pins
Folks,
What size are these? I need to replace my brake pads and the docs I have simply mention removing these two pins but make no mention of the size of the nut it uses. It looks like I need an allen wrench but I'm even guessing there. Anyone know? |
Ads |
#2
|
|||
|
|||
"Rich Heimlich" > wrote in message ... > Folks, > > What size are these? I need to replace my brake pads and the docs I > have simply mention removing these two pins but make no mention of the > size of the nut it uses. It looks like I need an allen wrench but I'm > even guessing there. > > Anyone know? It is an allen wrench, off hand I dont remember the size, possibly a 6mm |
#3
|
|||
|
|||
Not sure where the previous individual got their info but I just changed
rear brake pads on 2002 TC and the correct tool is the Torx T45 not an allen wrench. Works for front and rear calipers. |
#4
|
|||
|
|||
Not sure where the previous individual got their info but I just changed
rear brake pads on 2002 TC and the correct tool is the Torx T45 not an allen wrench. Works for front and rear calipers. |
#5
|
|||
|
|||
The next time you do a brake job on that vehicle take a look at the pin,
Its an allen bolt #7mm, yes a number 45 torx will work but it is not the correct tool to use. Glenn Beasley Chrysler Tech |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
2004 Chrysler Town and Country Minivan | Bob | Dodge | 5 | April 25th 04 03:47 AM |