If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#6
|
|||
|
|||
Blink wrote:
> I am planning on putting a 351W in my 88LX, but it currently has the > 2.3L EFI w/ T5. I know I will need an oil pan w/ pickup tube, headers > (BBK), motor mounts, dampener, tranny (AOD), flexplate, etc. I do have > a bunch of questions that I know you guys will be able to answer. It's completely and utterly not worth the hassle. Just changing the suspension bits, brakes and rear end will cost more than just buying a 5.0L fox body car with most of the bits you need already installed. Sell your existing car and get a Mustang that started out with a 5.0. It will be a MUCH easier process and probably cheaper. > I was wondering if I could put a regulator on the existing fuel system > to drop the pressure where it needs to be to run it to a carbed 351W? No. > I'm going to have a 351W w/ an AOD, do you think my current drive > shaft will work. No. I have a 2.3L w/ T-5. Or would I have to get one > from a 5.0 w/ AOD to fit mine? That would work. > When I take out the 2.3L, are there holes for the 351W to go into, or > do I have to fab up some brackets to make it fit? If so, does anybody > have any plans for them? Use 5.0 motor mounts. > Does anyone make 351W swap drop mounts or just 302 drop mounts for this > application? Dunno. > Also I have 3.27's in the rear end, should I go higher (w/ AOD)? I > have 3.73 and 4.11 available. 3.55 or 3.73 would be my choice. If it's a daily driver, you might even want a 3.08 with gas prices being what they are today. > Well that's all I have for, I appreciate any help anyone can give me. My advice is to sell your existing car and get a 5.0 LX notchback to work on. It will end up costing you less money in the long run. > > Thanks a lot No prob. Cheers, C |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
? 69 351W stroker tolerances | [email protected] | Ford Mustang | 4 | June 27th 05 04:31 AM |
351w into a CJ7 | Mike Duane Jr. | Jeep | 2 | June 15th 05 12:22 AM |
83 351W What will it fit? | Spike | Ford Mustang | 1 | May 8th 05 04:14 AM |
351W Troubles........................ | Ben Witek | 4x4 | 0 | February 4th 04 03:58 PM |