If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
My '97 Civic Ex is experiencing clutch slippage so I'm looking for a
reputable shop to do the repair work. Has anyone had experience with "Wallace Automotive" in Richmond, VA? I've been told that some "bearings" and the "clutch plate" needs replacing. I've taken it to a couple of places and they've told me that it will take a day or two (8-10 hrs) for about a $1,000. Is this reasonable? Suggestions appreciated. Thanks in advance, - Pat |
Ads |
#2
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
Pat Dreiding wrote:
> > My '97 Civic Ex is experiencing clutch slippage so I'm looking for a > reputable shop to do the repair work. > > Has anyone had experience with "Wallace Automotive" in Richmond, VA? > > I've been told that some "bearings" and the "clutch plate" needs replacing. > I've taken it to a couple of places and they've told me that it will take a > day or two (8-10 hrs) for about a $1,000. > > Is this reasonable? > > Suggestions appreciated. > > Thanks in advance, > - Pat ========================================== Why not tell us the history, the mileage, and what's been tried? (like the 5 W's) Maybe you don't need a shop at all? 'Curly' |
#3
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Pat Dreiding" > wrote in news7Y%f.384
$V73.172@trnddc06: > The car has 123K miles. When doing a semi-hard acceleration, the engines > RPMs increase, but the car doesn't goes faster. After a few secounds it > slowly start accelerating. You can "feel" the clutch slip. > > Are you familiar with any shops in Richmond? > > Thanks, > - Pat > > > > "'Curly Q. Links'" > wrote in message > ... >> Pat Dreiding wrote: >> > >> > My '97 Civic Ex is experiencing clutch slippage so I'm looking for a >> > reputable shop to do the repair work. >> > >> > Has anyone had experience with "Wallace Automotive" in Richmond, VA? >> > >> > I've been told that some "bearings" and the "clutch plate" needs > replacing. >> > I've taken it to a couple of places and they've told me that it will > take a >> > day or two (8-10 hrs) for about a $1,000. >> > >> > Is this reasonable? >> > >> > Suggestions appreciated. >> > >> > Thanks in advance, >> > - Pat >> >> >> ========================================== >> >> Why not tell us the history, the mileage, and what's been tried? (like >> the 5 W's) >> >> Maybe you don't need a shop at all? >> >> 'Curly' > > > Are you revving it too hard before the clutch has fully engaged? In my experience OEM Honda clutches slip badly and aren't for racing. When they heat up they'll slip even more. I once took my Civic on a 3 hour drive to Virginia Beach beatin the **** out of it the whole way, and when I finally got there my car just stopped going even though I was stepping on the gas because the clutch was slipping 100%. Had to roll it off the interstate and then wait about 10 minutes for the clutch disc to cool off before I could move again. I could smell it burning (clutch material smells kinda like burning hair, but worse). Got it switched to a performance clutch and flywheel and I can do some serious clutch popping and hard launches with no problems. If you go for a hard launch (or any kind of launch) and you feel the clutch slipping let off of it right away (don't rev it harder). Chances are it will get progressively worse. Take it easy on your clutch for a while. |
#4
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Crystal" > wrote in message 7.131... > > Are you revving it too hard before the clutch has fully engaged? In > my experience OEM Honda clutches slip badly and aren't for racing. > When they heat up they'll slip even more. I once took my Civic on a 3 > hour drive to Virginia Beach beatin the **** out of it the whole way, > and when I finally got there my car just stopped going even though I > was stepping on the gas because the clutch was slipping 100%. Had to > roll it off the interstate and then wait about 10 minutes for the > clutch disc to cool off before I could move again. I could smell it > burning (clutch material smells kinda like burning hair, but worse). > Got it switched to a performance clutch and flywheel and I can do > some serious clutch popping and hard launches with no problems. In years gone by 'woman owned and driven' meant that you were looking at a car that wasn't abused. That phrase hasn't meant that for quite awhile. {;^) |
#5
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Brian Smith" > wrote in
news:xl20g.29268$4S.11675@edtnps82: > > "Crystal" > wrote in message > 7.131... >> >> Are you revving it too hard before the clutch has fully engaged? In >> my experience OEM Honda clutches slip badly and aren't for racing. >> When they heat up they'll slip even more. I once took my Civic on a 3 >> hour drive to Virginia Beach beatin the **** out of it the whole way, >> and when I finally got there my car just stopped going even though I >> was stepping on the gas because the clutch was slipping 100%. Had to >> roll it off the interstate and then wait about 10 minutes for the >> clutch disc to cool off before I could move again. I could smell it >> burning (clutch material smells kinda like burning hair, but worse). >> Got it switched to a performance clutch and flywheel and I can do >> some serious clutch popping and hard launches with no problems. > > In years gone by 'woman owned and driven' meant that you were looking > at a car that wasn't abused. That phrase hasn't meant that for quite > awhile. {;^) > > > Driving slow makes me nervous unless I have a good stereo system to mellow me out. |
#6
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Pat Dreiding" > wrote in message
news:ehX%f.89$JY5.9@trnddc01... > My '97 Civic Ex is experiencing clutch slippage so I'm looking for a > reputable shop to do the repair work. > > Has anyone had experience with "Wallace Automotive" in Richmond, VA? > > I've been told that some "bearings" and the "clutch plate" needs > replacing. > I've taken it to a couple of places and they've told me that it will take > a > day or two (8-10 hrs) for about a $1,000. > > Is this reasonable? > > Suggestions appreciated. > > Thanks in advance, > - Pat > > That price sounds pretty high. I recommend you shop around some more - it will probably save you a few hundred dollars. There aren't many corners to cut that would lower the price, but some independent shops charge what they figure they can do it for rather than the "book" rate. A clutch job involves removing the transmission and replacing the clutch disk, the pressure plate that clamps the disk to the flywheel when the clutch pedal isn't depressed, the throwout bearing that lets the pressure plate turn while the fork (operated by the pedal) doesn't turn, and the pilot bearing in the flywheel that supports the end of the gearbox input shaft. The flywheel surface is lathed to make it flat again. We did the clutch in my son's Integra a couple months ago. The aftermarket parts were about $250 and the job was an all day affair for us amateurs, with the usual struggle to get the gearbox in place afterward. (I strained a muscle in my jaw from clenching my face - it hurt for three days!) Mike |
#7
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
I appreciate everyone's inputs. The car is a 97' Civic EX with 123K miles.
The questions I need answered a 1. Does anyone has a suggestion for reputable repair shop in Richmond, VA? 2. Has anyone had experience with "Wallace Automotive" in Richmond, VA? 3. Is $1,000 a reasonable charge for Clutch plate and Bearing replacement? Thanks again, - Pat "'Curly Q. Links'" > wrote in message ... > Pat Dreiding wrote: > > > > My '97 Civic Ex is experiencing clutch slippage so I'm looking for a > > reputable shop to do the repair work. > > > > Has anyone had experience with "Wallace Automotive" in Richmond, VA? > > > > I've been told that some "bearings" and the "clutch plate" needs replacing. > > I've taken it to a couple of places and they've told me that it will take a > > day or two (8-10 hrs) for about a $1,000. > > > > Is this reasonable? > > > > Suggestions appreciated. > > > > Thanks in advance, > > - Pat > > > ========================================== > > Why not tell us the history, the mileage, and what's been tried? (like > the 5 W's) > > Maybe you don't need a shop at all? > > 'Curly' |
#8
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Pat Dreiding" > wrote in
news:Kaa0g.8717$MU4.2285@trnddc03: > I appreciate everyone's inputs. The car is a 97' Civic EX with 123K > miles. > > The questions I need answered a > > 1. Does anyone has a suggestion for reputable repair shop in Richmond, > VA? > > 2. Has anyone had experience with "Wallace Automotive" in Richmond, > VA? > > 3. Is $1,000 a reasonable charge for Clutch plate and Bearing > replacement? > > Thanks again, > - Pat > > > > "'Curly Q. Links'" > wrote in message > ... >> Pat Dreiding wrote: >> > >> > My '97 Civic Ex is experiencing clutch slippage so I'm looking for >> > a reputable shop to do the repair work. >> > >> > Has anyone had experience with "Wallace Automotive" in Richmond, >> > VA? >> > >> > I've been told that some "bearings" and the "clutch plate" needs > replacing. >> > I've taken it to a couple of places and they've told me that it >> > will > take a >> > day or two (8-10 hrs) for about a $1,000. >> > >> > Is this reasonable? >> > >> > Suggestions appreciated. >> > >> > Thanks in advance, >> > - Pat >> >> >> ========================================== >> >> Why not tell us the history, the mileage, and what's been tried? >> (like the 5 W's) >> >> Maybe you don't need a shop at all? >> >> 'Curly' > > > $1000 is a bit much. I got a brand new lightweight flywheel, performance clutch disc, plate, plus bearings for about 400, and then installed a little less than 400. If he's getting you an OEM clutch plate and bearing, that's a lot of excess he's charging for labor. Albeit he's probably going on his pre-calculated "hours" to do the job, charging you $60 or more per hour. You'd have better luck driving to Barboursville and visiting High Speed Auto. Ask for Rick. It's a little less than 2 hours from Richmond. If you want directions let me know. |
#9
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Pat Dreiding" > wrote in
news:Kaa0g.8717$MU4.2285@trnddc03: > I appreciate everyone's inputs. The car is a 97' Civic EX with 123K > miles. > > The questions I need answered a > > 1. Does anyone has a suggestion for reputable repair shop in Richmond, > VA? > > 2. Has anyone had experience with "Wallace Automotive" in Richmond, > VA? > > 3. Is $1,000 a reasonable charge for Clutch plate and Bearing > replacement? The only thing I can comment on is the cost. One thousand bucks is way, WAY too much. Do you have a breakdown of the quote? If so, could you post it here, line by line? -- TeGGeR® The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
#10
|
|||
|
|||
Clutch slipping - looking for reputable shop in Richmond, VA
"Crystal" > wrote in message . 97.131... > > Driving slow makes me nervous unless I have a good stereo system to > mellow me out. To make the roads safer, perhaps you shouldn't be placed in a position of having care and control of a vehicle then. {;^) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New Clutch For Super Charged/boat pulling 4-Runner Recommendation | r | Technology | 15 | April 6th 06 07:33 PM |
2002 Passat 5-cylinder turbo clutch shot | [email protected] | VW water cooled | 8 | June 30th 05 02:39 AM |
Clutch slipping. Clutch cyl or need a new clutch | bobbob1015 | BMW | 6 | May 21st 05 12:19 AM |
Question about soggy clutch | TLittle | Technology | 1 | May 10th 05 05:44 PM |
1996 Chevy Cavalier Persistant Clutch Failures | [email protected] | Technology | 4 | April 26th 05 11:25 PM |