If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
lower body moulding
Hi,
I have a 1991 Jeep Cherokee Larado, and it has that lower body moulding about 8 inches high below the doors. It used to be silver, but with aging it is faded. I guess it is rubber? Is anyone aware of a product that can remove that faded dirty look? Thanks Hal |
Ads |
#2
|
|||
|
|||
lower body moulding
303 Protectant might help it look better temporarily but you would bet
better results by painting it with that Krylon paint made for plastic Painting it one of the Herculiner type Urethane products would be a permanent upgrade. .. "word9smith" > wrote in message oups.com... > Hi, > > I have a 1991 Jeep Cherokee Larado, and it has that lower body moulding > about 8 inches high below the doors. It used to be silver, but with > aging it is faded. I guess it is rubber? > Is anyone aware of a product that can remove that faded dirty look? > > Thanks > Hal > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
air filter body has goo in it and more questions... | Dan Hoskin | Jeep | 6 | February 21st 06 09:30 PM |
Body Work by Bambi | Jeepster | Jeep | 3 | January 6th 05 11:02 AM |
Confused! - 1968 Mustang Conv. lower ball joint?? | Jeffery | Ford Mustang | 3 | December 8th 04 02:56 AM |
97 Civic HX Rear Lower Shock Bushing | Brian | Honda | 0 | October 28th 04 04:45 PM |