If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2000 SL1 vibration/noise in front end
The car hit a 6 inch curb a couple of years back and ever since a slight
vibration/noise has gotten worse. When turning left at high speeds the noise gets louder and turning right it fades away. It has gotten worse ever since. Both the left and right wheel bearings have been replaced. The dealership couldn't find anything wrong. Anyone have any suggestions on what else could be the culprit? Thanks |
Ads |
#2
|
|||
|
|||
Sounds like a cv joint gone.
that is the symptom that a bad one gives. "bearcat500" > wrote in message lkaboutautos.com... > The car hit a 6 inch curb a couple of years back and ever since a slight > vibration/noise has gotten worse. When turning left at high speeds the > noise gets louder and turning right it fades away. It has gotten worse > ever since. Both the left and right wheel bearings have been replaced. The > dealership couldn't find anything wrong. Anyone have any suggestions on > what else could be the culprit? > > Thanks > |
#3
|
|||
|
|||
"Shawn" > wrote in message >...
> Sounds like a cv joint gone. > that is the symptom that a bad one gives. > > "bearcat500" > wrote in message > lkaboutautos.com... > > The car hit a 6 inch curb a couple of years back and ever since a slight > > vibration/noise has gotten worse. When turning left at high speeds the > > noise gets louder and turning right it fades away. It has gotten worse > > ever since. Both the left and right wheel bearings have been replaced. The > > dealership couldn't find anything wrong. Anyone have any suggestions on > > what else could be the culprit? > > > > Thanks > > I had a constant rattle throughout my Saturn and took it to the dealer who found no remedy. Later I discovered that the rubber motor mount had broken on one side. Replaced both and no more vibration. |
#4
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Parting Audi S4 2000 | mike | Audi | 11 | April 18th 09 02:16 AM |
Lift options for 2000 Chevy Blazer | Steve | 4x4 | 4 | June 15th 04 05:09 AM |