If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
It is risky, but if you are careful, the score will allow a chisel to
snap the tube. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's " wrote: > > Ok, I am not sure I understand. I have a threaded hole in the manifold > that has a hollow soft metal tube threaded into it. Are you guys sawing > down into the hole to divide the tube into pieces, or are you sawing > across the top to create a "screwdriver" slot into the tube? That > second one can't work, not enough metal. The first one seems risky to > the steel threads of the manifold. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | July 10th 05 05:24 AM |
QUESTION: 1996 GT Intake Manifold | EADGBE | Ford Mustang | 3 | June 26th 05 08:43 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 06:34 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | January 2nd 05 06:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 06:28 AM |