If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
97 Explorer transfer case problem
To all,
My transfer case got stuck in 4 low. When I shifted to 4 high it got stuck in an in between state and wouldn't go. Then I got blinking dash lights. I banged on the shift motor, tried a couple of more times and it went in to 4 high. This happened once before and a shop replaced the shift motor and all was well. I tried pulling the motor and after removing the bolts I could wiggle it and pull it from the transfer case about 1/8th of an inch. What is the trick to removing it? I think I either have a motor or limit switch problem. Could it be worse and be a major problem with the transfer case? ....Larry |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1997 Explorer Control Trac Problem | Pops54 | Ford Explorer | 4 | January 16th 06 02:22 AM |
92 Ford Explorer Clutch Problem in Cold Weather | sfstrickland | Ford Explorer | 6 | December 3rd 05 01:17 AM |
explorer 1997 transfer case | shanko | Ford Explorer | 0 | April 19th 05 03:13 PM |
Mountaineer AWD transfer case explosion! | 98xltman | Ford Explorer | 1 | February 26th 05 07:01 PM |
Cherokee transfer case forks broken | [email protected] | Jeep | 30 | December 12th 04 11:52 PM |