If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#7
|
|||
|
|||
"jim beam" wrote
> cam won't turn if the op has pistons at t.d.c. It's possible but rare. It's possible to move or rock slightly at TDC. I once found a cam stuck with no movements. Turns out someone used the wrong torque and bearing on the cam. In this case the timing belt shatters. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Crankshaft Pulley Bolt on 1989 Accord SE-i: My story | justinreigle (at) gmail (dot) com | Honda | 15 | March 1st 05 04:47 AM |
Honda Crankshaft pulley falls off | jjeansonne | Honda | 6 | February 28th 05 05:04 AM |
Crankshaft pulley bolt on Hondas | No name yet | Honda | 10 | January 9th 05 04:10 PM |
Crankshaft Pulley Removal '92 4.0 | Ulysses | Ford Explorer | 10 | November 6th 04 09:43 PM |
Need Crankshaft Pulley - Harmonic Balancer | Kirsten | Saturn | 1 | May 24th 04 12:46 PM |