If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#3
|
|||
|
|||
"Ted" > wrote in message ... > > "Matthew Maddock" > wrote in > message ... >> again, 1995 A6 2.6 SE >> >> I don't have a manual, so just have a couple of questions about >> the dash display. >> >> 1. When I start up, the multi-display shows bulb failure until >> I press the brake pedal (at which point it says "OK") - is this >> normal? >> >> 2. Again on start up the trip odometer displays (flashes) "ln.2" >> for about 10-15 seconds - what is it on about???!!! >> >> 3. On the OBC display, there is one function with a G above a dot >> with an arrow pointing away from the dot. What on earth does it >> show?! I can't think - it seems to display anything from about >> 0.1 - 3.0 and I can't think of what it is trying to tell me! >> >> Thanks in advance for any help, >> >> Matt. > > I've had No 1 it concluded in one of the break light filaments, although > broken, somehow made contact once the break/clutch pedal was pressed. I > suggest you change both break bulbs. I suggest both because I went through > a series of replacing the rear offside break light until one time I > replaced both and all has been OK since. > > > 1n2 means its time for a service, Steve. |
Thread Tools | |
Display Modes | |
|
|