If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
jack points
I bought a hydraulic trolley jack and a couple of jack stands. Can I
jack up the car anywhere along the edge or must I use the jack points near the front and rear wheels/fenders? Ultimately I want to do my own oil changes, so I need to jack up the car, then place the jack stands underneath. |
Ads |
#2
|
|||
|
|||
"z4869375" > wrote in message
... > > Ultimately I want to do my own oil changes, so I need to jack up the > car, then place the jack stands underneath. Wouldn't it be easier to just get a set of $20 ramps? You don't need the tires off the ground for an oil change. I use ramps for anything the tires don't need to be off the ground for. I use my jack for changing tires, doing brakes, stuff like that. Right tool for the right job. |
#3
|
|||
|
|||
On Sat, 16 Oct 2004 16:31:05 GMT, "Seth"
> wrote: >"z4869375" > wrote in message .. . >> >> Ultimately I want to do my own oil changes, so I need to jack up the >> car, then place the jack stands underneath. > >Wouldn't it be easier to just get a set of $20 ramps? You don't need the >tires off the ground for an oil change. > >I use ramps for anything the tires don't need to be off the ground for. I >use my jack for changing tires, doing brakes, stuff like that. > >Right tool for the right job. Actually ramps do sound like a better idea since they are safer. When I looked at ramps, I thought I would have problems getting my car up them (RSX-S) since I believe its slightly lower than other Hondas. |
#4
|
|||
|
|||
On Sat, 16 Oct 2004 11:48:22 -0400, z4869375 >
wrote: >I bought a hydraulic trolley jack and a couple of jack stands. Can I >jack up the car anywhere along the edge or must I use the jack points >near the front and rear wheels/fenders? If you could do that, why would they put in specially reinforced jacking points? You can also place your jack under either of the lower suspension arms though, or most anywhere under the subframe in which the engine is mounted and to which the suspension arms are bolted. At the front this is usually directly under the radiator although it may be hiddden by plastic splash shields. Always use your jack stands, never the jack alone. Usually those are placed under the suspension arms or the subframe. Make sure the little 'crown' at the end of the jack arm is so placed that it won't slip. Trolley jacks are meant to be used on a hard, flat surface. If you have the park brake on so the car can't roll (which you should) the trolley jack has to be free to move a little as its arm swings up. If you're on soft ground and the wheels dig in, the 'crown' may be pulled off a narrow object like a suspension arm. You don't have to go very far under the car to change the oil, but if you plan on changing your oil filter you're going to have to go way under there and the further up the car is the easier it is. Make sure it's stable and safe. |
#5
|
|||
|
|||
"z4869375" > wrote in message
... > On Sat, 16 Oct 2004 16:31:05 GMT, "Seth" > > wrote: > >>"z4869375" > wrote in message . .. >>> >>> Ultimately I want to do my own oil changes, so I need to jack up the >>> car, then place the jack stands underneath. >> >>Wouldn't it be easier to just get a set of $20 ramps? You don't need the >>tires off the ground for an oil change. >> >>I use ramps for anything the tires don't need to be off the ground for. I >>use my jack for changing tires, doing brakes, stuff like that. >> >>Right tool for the right job. > > Actually ramps do sound like a better idea since they are safer. When > I looked at ramps, I thought I would have problems getting my car up > them (RSX-S) since I believe its slightly lower than other Hondas. I believe I've seen different height and length ramps. Just get a long low set and you should be able to drive right up. |
#6
|
|||
|
|||
"z4869375" > wrote in message
... > I bought a hydraulic trolley jack and a couple of jack stands. Can I > jack up the car anywhere along the edge or must I use the jack points > near the front and rear wheels/fenders? > Ultimately I want to do my own oil changes, so I need to jack up the > car, then place the jack stands underneath. Use a one foot 2x4 or 4x4 as a support if you jack the center. Some cars can be heavier so avoid bending the frame. Ramps can waste storage space and unsightly compared to the bottle jack -- Burt |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jack lift point on front of Voyager | retiredusarmy | Chrysler | 8 | October 17th 04 12:14 PM |
help - identify very old vehicle jack handle. | Antique cars | 0 | April 15th 04 02:37 AM | |
Hitch mounted Hi Lift jack? | Rob Gendreau | 4x4 | 6 | February 28th 04 08:50 AM |