|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 10th 05, 05:23 PM
|
|||
|
|||
where is the refrigerant service valve in a 2001 LW300
|
| Ads |
|
#2
June 13th 05, 01:23 PM
|
|||
|
|||
|
Off the top of my head, I can't recall. Just find the suction side line from
the compressor (the side that goes to the firewall directly) and trace it back to the firewall. the service valve should be somewhere in this line. If you are adding refrigerant, be sure to purge any air from the charging hose by cracking the valve on the can briefly. "Tuneup" > wrote in message ... >
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | June 8th 05 05:28 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 2 | April 22nd 05 05:32 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 21st 05 05:33 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | March 6th 05 05:29 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
Linear Mode
