If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can a type 2 body be removed from the frame for body work?
I see a lot of discussion about bugs having the body removed from the
frame. I would like to clean up the frame of rust, replace some sections of my floor pan and get the engine/tranny out of my way for some serious body work. Is it practical to remove the type 2 body from the frame? Or is the body an integral part of the frame like on some uni-body cars. Thanks Chuck |
Ads |
#3
|
|||
|
|||
NO can't be done cept with torch, dianmite or air chisle.
> wrote in message oups.com... >I see a lot of discussion about bugs having the body removed from the > frame. > I would like to clean up the frame of rust, replace some sections of my > floor pan and get the engine/tranny out of my way for some serious body > work. > Is it practical to remove the type 2 body from the frame? Or is the > body an integral part of the frame like on some uni-body cars. > > Thanks > Chuck > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Body Work by Bambi | Jeepster | Jeep | 3 | January 6th 05 11:02 AM |
Place in Salt Lake City to do body work | root | Honda | 0 | January 5th 05 04:00 PM |
body work need in los angeles area | Antique cars | 0 | October 20th 04 09:49 AM | |
Body Work Questions | James Sutherland | Dodge | 2 | September 23rd 04 02:00 AM |