If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2002 Explorer Heater Hose Tee
We have an Eddie Bauer 2002 Explorer. Today, we blew a heater hose
fitting. It seems like a tee that was press fit onto the heater hose. It seems that the hose goes from the thermostat, back to the tee, and is then routed twards the back of the vehicle and towards the (passgenger)firewall. I liked it better when there were clamps ! This seems as though it might have been press fit with the fitting covering the od of the hose. !? Can I just cut out the tee and pop a metal 1/2 " tee in the id of the hose? And if so. where can I find one - seems like these tee's are hard to find. Thanks... ....Mike |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
source for right angle heater hose fitting? | Nate Nagel[_2_] | Technology | 20 | January 23rd 08 12:36 PM |
Heater hose.... | BAK | Mazda | 1 | August 4th 06 06:26 AM |
Replacing heater hose. | Mal Osborne | Mazda | 5 | May 23rd 06 11:29 AM |
Heater hose replacement | Jon C | Technology | 14 | January 23rd 06 08:21 PM |
Heater Inlet hose | tfandango | Ford Explorer | 3 | March 11th 05 08:45 PM |