If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
New Top Concern/Issue
I purchased and installed a cloth top on my 99 miata from Duetto. I did it
myself and it still looks great. The installation part of the instructions could use some work, just remember how it went apart and use your common sense. My concern now is the material/seam that goes across the car about three inches above the rear window. My #3 bow (cross bar) rubs against the seam when raising and lowering the top. When lowering the top down the bow goes smoothly over the seam and the stitching. The problem is raising the top. The bow goes 'against the grain' with a very likelyhood of fraying the material that's past the seam and putting additional pressure on the seams themselves. Has anyone else made this observation? Is there anything I can do to minimize the chaffing and rubbing? Could frabic glue be used to hold down the material beyond the stitching? Any thoughts? TIA, - Pat |
Ads |
#2
|
|||
|
|||
"Pat Dreiding" > wrote:
>I purchased and installed a cloth top on my 99 miata from Duetto. I did it >myself and it still looks great. >The installation part of the instructions could use some work, just remember >how it went apart and use your common sense. > >My concern now is the material/seam that goes across the car about three >inches above the rear window. >My #3 bow (cross bar) rubs against the seam when raising and lowering the >top. >When lowering the top down the bow goes smoothly over the seam and the >stitching. >The problem is raising the top. >The bow goes 'against the grain' with a very likelyhood of fraying the >material that's past the seam and putting additional pressure on the seams >themselves. >Has anyone else made this observation? >Is there anything I can do to minimize the chaffing and rubbing? >Could frabic glue be used to hold down the material beyond the stitching? >Any thoughts? Cover the bow with material that is softer than the top material? Cover the seam? Is there visible evidence of wear, and where? Leon -- Leon van Dommelen Bozo, the White 96 Sebring Miata .) http://www.dommelen.net/miata EXIT THE INTERSTATES (Jamie Jensen) |
#3
|
|||
|
|||
Leon,
Thank you for your reply. I did get a bow cover to use. There is no visible evidence of wear, maybe just a parnoid concern of mine. The maufacturer told me that the seams have four layers of material that are heat sealed (I wish there was some evidence of the heat seal). But they assured me that there will be no problem and that the top has a 5 year warranty in-case something does happen. I' going to keep an eye on it. I have taken a few pictures and will continue to take them over time. If something does go wrong I'll at least have a history trail. So, for the moment, this issue is no longer a concern. Regards, - Pat "Leon van Dommelen" > wrote in message ... > "Pat Dreiding" > wrote: > > >I purchased and installed a cloth top on my 99 miata from Duetto. I did it > >myself and it still looks great. > >The installation part of the instructions could use some work, just remember > >how it went apart and use your common sense. > > > >My concern now is the material/seam that goes across the car about three > >inches above the rear window. > >My #3 bow (cross bar) rubs against the seam when raising and lowering the > >top. > >When lowering the top down the bow goes smoothly over the seam and the > >stitching. > >The problem is raising the top. > >The bow goes 'against the grain' with a very likelyhood of fraying the > >material that's past the seam and putting additional pressure on the seams > >themselves. > >Has anyone else made this observation? > >Is there anything I can do to minimize the chaffing and rubbing? > >Could frabic glue be used to hold down the material beyond the stitching? > >Any thoughts? > > Cover the bow with material that is softer than the top material? > Cover the seam? > > Is there visible evidence of wear, and where? > > Leon > > -- > Leon van Dommelen Bozo, the White 96 Sebring Miata .) > http://www.dommelen.net/miata > EXIT THE INTERSTATES (Jamie Jensen) |
Thread Tools | |
Display Modes | |
|
|