If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
more help please!
again, 1995 A6 2.6 SE
I don't have a manual, so just have a couple of questions about the dash display. 1. When I start up, the multi-display shows bulb failure until I press the brake pedal (at which point it says "OK") - is this normal? 2. Again on start up the trip odometer displays (flashes) "ln.2" for about 10-15 seconds - what is it on about???!!! 3. On the OBC display, there is one function with a G above a dot with an arrow pointing away from the dot. What on earth does it show?! I can't think - it seems to display anything from about 0.1 - 3.0 and I can't think of what it is trying to tell me! Thanks in advance for any help, Matt. |
Ads |
#2
|
|||
|
|||
"Matthew Maddock" > wrote in message ... > again, 1995 A6 2.6 SE > > I don't have a manual, so just have a couple of questions about > the dash display. > > 1. When I start up, the multi-display shows bulb failure until > I press the brake pedal (at which point it says "OK") - is this > normal? > > 2. Again on start up the trip odometer displays (flashes) "ln.2" > for about 10-15 seconds - what is it on about???!!! > > 3. On the OBC display, there is one function with a G above a dot > with an arrow pointing away from the dot. What on earth does it > show?! I can't think - it seems to display anything from about > 0.1 - 3.0 and I can't think of what it is trying to tell me! > > Thanks in advance for any help, > > Matt. I've had No 1 it concluded in one of the break light filaments, although broken, somehow made contact once the break/clutch pedal was pressed. I suggest you change both break bulbs. I suggest both because I went through a series of replacing the rear offside break light until one time I replaced both and all has been OK since. |
#3
|
|||
|
|||
"Ted" > wrote in message ... > > "Matthew Maddock" > wrote in > message ... >> again, 1995 A6 2.6 SE >> >> I don't have a manual, so just have a couple of questions about >> the dash display. >> >> 1. When I start up, the multi-display shows bulb failure until >> I press the brake pedal (at which point it says "OK") - is this >> normal? >> >> 2. Again on start up the trip odometer displays (flashes) "ln.2" >> for about 10-15 seconds - what is it on about???!!! >> >> 3. On the OBC display, there is one function with a G above a dot >> with an arrow pointing away from the dot. What on earth does it >> show?! I can't think - it seems to display anything from about >> 0.1 - 3.0 and I can't think of what it is trying to tell me! >> >> Thanks in advance for any help, >> >> Matt. > > I've had No 1 it concluded in one of the break light filaments, although > broken, somehow made contact once the break/clutch pedal was pressed. I > suggest you change both break bulbs. I suggest both because I went through > a series of replacing the rear offside break light until one time I > replaced both and all has been OK since. > > > 1n2 means its time for a service, Steve. |
#4
|
|||
|
|||
The message >
from Matthew Maddock > contains these words: > 1. When I start up, the multi-display shows bulb failure until > I press the brake pedal (at which point it says "OK") - is this > normal? Yes. If you look closely you'll see it's not a bulb warning but has two curved lines either side, showing it's a brake warning instead. It waits for you to press the brake pedal to check that the ABS input switch is working. -- Skipweasel. Ivor Cutler - "Never knowingly understood." |
Thread Tools | |
Display Modes | |
|
|