|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 22nd 04, 03:47 AM
|
|||
|
|||
95 SL2 Metalic Vibrating Noise
at about 1200-1900 RPM's it sounds like comething is rattling loose. I had
my cat replaced about a month ago so I know thats good. No Codes. Any Ideas ? 
|
| Ads |
|
#2
November 22nd 04, 04:03 AM
|
|||
|
|||
|
>at about 1200-1900 RPM's it sounds like comething is rattling loose. I had
>my cat replaced about a month ago so I know thats good. >No Codes. > >Any Ideas ? Possible worn upper engine mount?
|
|
#3
November 22nd 04, 04:39 AM
|
|||
|
|||
|
On Sun, 21 Nov 2004 19:47:10 -0800, > wrote:
>at about 1200-1900 RPM's it sounds like comething is rattling loose. I had >my cat replaced about a month ago so I know thats good. >No Codes. > >Any Ideas ? > If you can get under the car(safely) I would take a small hammer and quickly tap all the bolts of the exhaust system. Listen for a 'thud' to indiciate a loose bolt, also check for missing exhaust mounts. hth, tom @ www.URLBee.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | January 2nd 05 05:15 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
| New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |
Linear Mode
