king pins / link pins

I took the body off of my 63 beetle the other day, just to do I couple
of jobs easier.

I noticed that the drivers side inner tie rod was loose, so am
replacing that.
Also noticed that the upper drivers side link pin has stacks of
movement in it (Side to side)

Is there a way to tighten this, or am I best replacing it?
Can someone give me a quick run-down on how this is done?

Cheers

What are some other tasks I should do while the body is off?

"zigford" > schreef in bericht > I noticed that the
drivers side inner tie rod was loose, so am
> replacing that.
> Also noticed that the upper drivers side link pin has stacks of
> movement in it (Side to side)

I recon you mean movement at the upper and lower link pin?
(rocking the wheel top and bottom)

> Is there a way to tighten this, or am I best replacing it?
> Can someone give me a quick run-down on how this is done?

If it is just play you can adjust it by loosening the 17mm bolt and tighten
the linkpin (15mm? open wrench)

This might shet some light:
http://geocities.com/sandrail71/link_pin_rebuild.htm

hth
Roger