A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers » Chrysler
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

I have a problem with my A/C on my 300M.



 
 
Thread Tools Display Modes
  #1  
Old May 28th 05, 10:05 PM
Marc
external usenet poster
 
Posts: n/a
Default I have a problem with my A/C on my 300M.

The pressure seems OK the clutch is engaging on the compressor but no cold
air! I set the A/C all the way down and nothing happens. The low pressure
hose is warm and the high pressure side is very hot. Any suggestions?

Marc


Ads
  #2  
Old May 28th 05, 11:53 PM
phil
external usenet poster
 
Posts: n/a
Default

ion the fuse bos there is a fuse that sits up higher than the rest
unplug it for 5 minutes reinsert and then start car up and let it do it's thing

under the conditions the software of the keyless entry mess's with the bcm and
the hvac module and it woun't calibrate properly this cahnges that

Marc wrote:

> The pressure seems OK the clutch is engaging on the compressor but no cold
> air! I set the A/C all the way down and nothing happens. The low pressure
> hose is warm and the high pressure side is very hot. Any suggestions?
>
> Marc


  #3  
Old May 29th 05, 06:10 PM
Marc
external usenet poster
 
Posts: n/a
Default

Thanks Phil - that was the problem. I thought it would be something like
that - sort of like unplugging a consumer electronics piece for 20 minutes
and plug it back in and it works again!

Marc


"phil" > wrote in message ...
> ion the fuse bos there is a fuse that sits up higher than the rest
> unplug it for 5 minutes reinsert and then start car up and let it do it's

thing
>
> under the conditions the software of the keyless entry mess's with the bcm

and
> the hvac module and it woun't calibrate properly this cahnges that
>
> Marc wrote:
>
> > The pressure seems OK the clutch is engaging on the compressor but no

cold
> > air! I set the A/C all the way down and nothing happens. The low

pressure
> > hose is warm and the high pressure side is very hot. Any suggestions?
> >
> > Marc

>



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
98 Explorer - Cold Starting/ Idle Problem tj Ford Explorer 6 March 16th 05 04:22 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 10 December 18th 04 06:15 AM
rec.autos.makers.chrysler FAQ, Part 1/6 Dr. David Zatz Chrysler 10 December 2nd 04 06:19 AM
New *FREE* Corvette Discussion Forum JLA ENTERPRISES TECHNOLOGIES INTEGRATION Corvette 12 November 30th 04 07:36 PM
87 TBI Suburban bog / acceleration problem Michael Vosk 4x4 8 September 29th 04 04:55 AM


All times are GMT +1. The time now is 10:03 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.