If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Spark plug cleaning
My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know
that's not a heck of a lot of money, but it hurts to throw them out just cause they have a little bit of carbon on them. How to clean spark plugs? Ideas? -- Christopher A. Young Learn more about Jesus www.lds.org www.mormons.com |
Ads |
#2
|
|||
|
|||
With one of these
http://www.thetoolwarehouse.net/shop/AP-7833.html "Stormin Mormon" > wrote in message . .. > My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > that's not a heck of a lot of money, but it hurts to throw them out just > cause they have a little bit of carbon on them. > > How to clean spark plugs? Ideas? > > > -- > > Christopher A. Young > Learn more about Jesus > www.lds.org > www.mormons.com > > > |
#3
|
|||
|
|||
"Stormin Mormon" > writes:
> My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > that's not a heck of a lot of money, but it hurts to throw them out just > cause they have a little bit of carbon on them. > > How to clean spark plugs? Ideas? Traditionally, sandblasting. Try to find a shop in your area that still has a plug sandblaster. -- -Stephen H. Westin Any information or opinions in this message are mine: they do not represent the position of Cornell University or any of its sponsors. |
#4
|
|||
|
|||
In article >,
"Stormin Mormon" > wrote: > My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > that's not a heck of a lot of money, but it hurts to throw them out just > cause they have a little bit of carbon on them. > > How to clean spark plugs? Ideas? There's a sandblaster box made specifically for the purpose. No idea on price or who sells 'em. Failing that, a wire brush can usually accomplish the job. -- Don Bruder - - New Email policy in effect as of Feb. 21, 2004. Short form: I'm trashing EVERY E-mail that doesn't contain a password in the subject unless it comes from a "whitelisted" (pre-approved by me) address. See <http://www.sonic.net/~dakidd/main/contact.html> for full details. |
#5
|
|||
|
|||
WRONG !!!
A so called wire brush will render those plugs unuseable buddy ! Stop, do not pass go ! Do not claim your minute of fame! That so called bright idea of useing a wire brush is an idiotic idea. Unless of coarse you can prove that the carbon from the wire(steel) will not coat or leave behind traces of carbon on the porcelain? insulator. Unless one uses a brand new wire brush(stainless wire) Fig "Don Bruder" > wrote in message ... > In article >, > "Stormin Mormon" > wrote: > > > My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > > that's not a heck of a lot of money, but it hurts to throw them out just > > cause they have a little bit of carbon on them. > > > > How to clean spark plugs? Ideas? > > There's a sandblaster box made specifically for the purpose. No idea on > price or who sells 'em. Failing that, a wire brush can usually > accomplish the job. > > -- > Don Bruder - - New Email policy in effect as of Feb. 21, 2004. > Short form: I'm trashing EVERY E-mail that doesn't contain a password in the > subject unless it comes from a "whitelisted" (pre-approved by me) address. > See <http://www.sonic.net/~dakidd/main/contact.html> for full details. |
#6
|
|||
|
|||
In article >,
"Figjam\(cable\)" > wrote: > WRONG !!! > A so called wire brush will render those plugs unuseable buddy! Really? News to me, bub. It's been my standard method of coping with fouled plugs since before I got a driver's license - From lawn mowers and go-karts, to motorbikes, cars, and trucks - Or anything else that uses a spark plug. Guess what? I've never - as in not one single time - EVER - had a plug problem of any kind with a brush-cleaned plug. Unless, of course, you count the crud buildup that convinces me to pull the plugs and take a brush to 'em in the first place. > Stop, do not pass go ! > Do not claim your minute of fame! > That so called bright idea of useing a wire brush is an idiotic idea. Kinda like your post is idiotic? Back it on down a notch or three, son. By the sound of things, you're running more than a little rich, and only hitting on about four out of six, besides. > Unless of coarse you can prove that the carbon from the wire(steel) > will not coat or leave behind traces of carbon on the porcelain? insulator. Tell ya what - Since it's your claim that it will, how about we use standard debating methodology, and *YOU PROVE THAT IT DOES*. (Hint: The percentage of carbon in the steel is so low as to be effectively nonexistent in your scenario, and even if that weren't the case, it's bound up in the alloy, not laying on the surface waiting to be bumped loose on an unsuspecting plug) > Unless one uses a brand new wire brush(stainless wire) Spare me, son. If you had half a clue, you'd know as well as I do that stainless steel (like ANY steel, regardless of the type) has carbon in the alloy. Get back with me after somebody buys you an economy-size box of clue. > > > > "Don Bruder" > wrote in message > ... > > In article >, > > "Stormin Mormon" > wrote: > > > > > My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > > > that's not a heck of a lot of money, but it hurts to throw them out just > > > cause they have a little bit of carbon on them. > > > > > > How to clean spark plugs? Ideas? > > > > There's a sandblaster box made specifically for the purpose. No idea on > > price or who sells 'em. Failing that, a wire brush can usually > > accomplish the job. > > > > -- > > Don Bruder - - New Email policy in effect as of Feb. 21, > 2004. > > Short form: I'm trashing EVERY E-mail that doesn't contain a password in > the > > subject unless it comes from a "whitelisted" (pre-approved by me) address. > > See <http://www.sonic.net/~dakidd/main/contact.html> for full details. > > -- Don Bruder - - New Email policy in effect as of Feb. 21, 2004. Short form: I'm trashing EVERY E-mail that doesn't contain a password in the subject unless it comes from a "whitelisted" (pre-approved by me) address. See <http://www.sonic.net/~dakidd/main/contact.html> for full details. |
#7
|
|||
|
|||
Wish I had enough of an air compressor to support one of those.
Anyhow, I did get the van running again. The problem turned to be a very dirty carb. Most of a can of Gold Eagle carb cleaner spray (tolune, acetone, alcohol, and all the good stuff) stripped off the black coating. Much better, now. -- Christopher A. Young Learn more about Jesus www.lds.org www.mormons.com "Rusted" > wrote in message .. . With one of these http://www.thetoolwarehouse.net/shop/AP-7833.html "Stormin Mormon" > wrote in message . .. > My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > that's not a heck of a lot of money, but it hurts to throw them out just > cause they have a little bit of carbon on them. > > How to clean spark plugs? Ideas? > > > -- > > Christopher A. Young > Learn more about Jesus > www.lds.org > www.mormons.com > > > |
#8
|
|||
|
|||
I've used a wire brush for many years. Can't say as how it's ever given me
problems. -- Christopher A. Young Learn more about Jesus www.lds.org www.mormons.com "Figjam(cable)" > wrote in message ... WRONG !!! A so called wire brush will render those plugs unuseable buddy ! Stop, do not pass go ! Do not claim your minute of fame! That so called bright idea of useing a wire brush is an idiotic idea. Unless of coarse you can prove that the carbon from the wire(steel) will not coat or leave behind traces of carbon on the porcelain? insulator. Unless one uses a brand new wire brush(stainless wire) Fig "Don Bruder" > wrote in message ... > In article >, > "Stormin Mormon" > wrote: > > > My Dodge van has 8 cylinders. Eight plugs. Two bucks each. $16. I know > > that's not a heck of a lot of money, but it hurts to throw them out just > > cause they have a little bit of carbon on them. > > > > How to clean spark plugs? Ideas? > > There's a sandblaster box made specifically for the purpose. No idea on > price or who sells 'em. Failing that, a wire brush can usually > accomplish the job. > > -- > Don Bruder - - New Email policy in effect as of Feb. 21, 2004. > Short form: I'm trashing EVERY E-mail that doesn't contain a password in the > subject unless it comes from a "whitelisted" (pre-approved by me) address. > See <http://www.sonic.net/~dakidd/main/contact.html> for full details. |
#9
|
|||
|
|||
I've been wire brushing spark plugs since 1976 or so.
-- Christopher A. Young Learn more about Jesus www.lds.org www.mormons.com "Don Bruder" > wrote in message ... In article >, "Figjam\(cable\)" > wrote: > WRONG !!! > A so called wire brush will render those plugs unuseable buddy! Really? News to me, bub. It's been my standard method of coping with fouled plugs since before I got a driver's license - From lawn mowers and go-karts, to motorbikes, cars, and trucks - Or anything else that uses a spark plug. Guess what? I've never - as in not one single time - EVER - had a plug problem of any kind with a brush-cleaned plug. Unless, of course, you count the crud buildup that convinces me to pull the plugs and take a brush to 'em in the first place. > Stop, do not pass go ! > Do not claim your minute of fame! > That so called bright idea of useing a wire brush is an idiotic idea. |
#10
|
|||
|
|||
"Stormin Mormon" > wrote in message . .. > I've been wire brushing spark plugs since 1976 or so. > ` Same here. > -- > > Christopher A. Young > Learn more about Jesus > www.lds.org > www.mormons.com > > > "Don Bruder" > wrote in message > ... > In article >, > "Figjam\(cable\)" > wrote: > > > WRONG !!! > > A so called wire brush will render those plugs unuseable buddy! > > Really? News to me, bub. It's been my standard method of coping with > fouled plugs since before I got a driver's license - From lawn mowers > and go-karts, to motorbikes, cars, and trucks - Or anything else that > uses a spark plug. Guess what? I've never - as in not one single time - > EVER - had a plug problem of any kind with a brush-cleaned plug. Unless, > of course, you count the crud buildup that convinces me to pull the > plugs and take a brush to 'em in the first place. > > > > Stop, do not pass go ! > > Do not claim your minute of fame! > > That so called bright idea of useing a wire brush is an idiotic idea. > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Corvette spark plug wire set | [email protected] | Corvette | 0 | January 1st 05 11:16 PM |
Non-Factory Spark Plug Gap Setting | Drink | Corvette | 6 | October 11th 04 03:11 PM |
1995 Audi A6 Spark Plug Torque Spec etc. | Soyboy | Audi | 1 | July 27th 04 04:19 PM |