If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
89 YJ SYE
I ordered a Tom Wood CV driveshaft and tail shaft conversion kit today. I'll
be installing it when it arrives. Should I pull the transfer case? I've heard it both ways for pressing bearings in and out.. will this be required? Besides lube, what else will I need? Got the YJ home safe with a trailer. Good thing I didn't try to drive it back, the rear driveline was binding pretty bad. Thanks, Carl 89 YJ SOA, Winch, ect |
Ads |
Thread Tools | |
Display Modes | |
|
|