If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#27
|
|||
|
|||
I got a website http://www.pac-audio.com/oem1kits/oem1search.htm from
someone who replied earlier, did a little research on that site and it said that if you have sound in the front, but nothing in the rear you need to turn on the rear amps. Looking over the connections again, I found one wire from the harness, and from the receiver that weren't being used, turns out they were the amp "on" wire on the harness, and the power antenna/remote turn on wire on the receiver. I connected them together without a relay, and it works ok, UNTIL I turn it up real loud, or have too much bass in the sound, then the rear channels drop in and out, until I lower the volume. Maybe the amp is getting too "hot" a signal and causes it to drop out? I guess I can use it like that for now, until I can get some new speakers in the back. Thanks to all!!, Snydley "mic canic" > wrote in message ... > you can use the stock speakers with amps you just have to power up the amps > using a relay and getting it's trigger from the remote turn on wire off the > aftermarket radio > > Snydley wrote: > > > I removed the Infinity CD/Tape/Radio unit from my 2000 Caravan because the > > CD player no longer works and I am attempting to replace it with an > > aftermarket unit. I bought a dash adapter and wiring kit so I wouldn't have > > to cut/splice any of the wires. > > Now that I have it installed the rear speakers won't work. Wanting to rule > > out bad rear channels in the receiver, I swapped the front and rear speaker > > connections. The front speakers still work using the rear channels of the > > receiver, so I know the receiver is ok, and it must be something with the > > wiring. I tried to get continuity with my V/Ohm meter and couldn't get any > > with the rear speakers. > > As a last ditch effort, I went to the local Mopar garage and told the guy at > > the service counter my story and he told me that "you can put an Infinity > > receiver in a non-Infinity vehicle, but you can't put an aftermarket radio > > in an Infinity equipped vehicle without replacing the speakers. Each speaker > > has it's own amp on the back of it". By that I figured he meant a diode or > > transformer of some kind. > > Is there any way I can use the stock speakers? Remove the diode/transformer > > or something. > > What do people usually do in this instance? > > > > Thanks, > > Snydley > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problems! 2000 Caravan Sport and Infinity Sound | Snydley | Dodge | 42 | January 3rd 05 07:15 PM |