If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
On Mon, 22 Nov 2004 00:49:35 GMT, "Jim Warman"
> wrote: >50 ma.... that's .050 amps - after all the modules have gone to sleep. > There ya go. > >"Big Bill" > wrote in message .. . >> On Sun, 21 Nov 2004 02:41:55 -0500, "*selah*" > >> wrote: >> >>>Thanks to everyone for the input. >>> >>>Was wondering what the current draw should be? >> >> Not positive (it will vary from vehicle to vehicle) but it should be >> in the low milliamp range. >> >> -- >> Bill Funk >> Change "g" to "a" > -- Bill Funk Change "g" to "a" |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |