|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 29th 04, 09:10 PM
|
|||
|
|||
Set Pinion Factor
In addition to the high idle, my wife's 96 Sebring also has an issue with
the speedometer. Namely it doesn't work. All other gauges work, but not the speedometer. I pulled the PCM off so I could get better access to the EGR Pipe to fix it. I noticed a sticker on the back of the PDM. It said "Speedometer will not work unless pinion factor is set." A Google produced a few results which leads me to believe that the Pinion Factor must be set by a tech. Am I reading that right? Thanx 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1997 Intrepid Rack and Pinion | Joe D. | Dodge | 35 | January 6th 06 07:04 PM |
| Does the Chrysler Corporation Car Production Broadcast paper show pinion bearing preload and pinion nut torque? | JP | Dodge | 6 | September 21st 04 02:16 AM |
Threaded Mode