If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
300M mirror gone berserk
The car was back in for another regular service yesterday, but I had
told them in advance (again) about the mirror problem. They eventually replaced the mirror itself, and so far all seems to be well. MB On 08/13/04 11:05 am I wrote: > Now the passenger-side mirror sometimes stays tilted down when I shift > out of reverse. > > When at the dealership this mornimg for a regular service I asked about > this, and they said I'll have to schedule a longer appointment for them > to check it out. IOW, this seems not to be a known problem with a known > solution. >> The driver's-side mirror on our '02 300M is behaving strangely: when I >> shift into reverse, the mirror tilts down waaaay more than it used to >> -- down so far as to be pretty much useless -- and, when the shifter >> is not in reverse, does not always point in the same place each time >> the same set of adjustments is invoked, either with the remote or by >> pressing the button. >> >> Any ideas? |
Ads |
#2
|
|||
|
|||
The car was back in for another regular service yesterday, but I had
told them in advance (again) about the mirror problem. They eventually replaced the mirror itself, and so far all seems to be well. MB On 08/13/04 11:05 am I wrote: > Now the passenger-side mirror sometimes stays tilted down when I shift > out of reverse. > > When at the dealership this mornimg for a regular service I asked about > this, and they said I'll have to schedule a longer appointment for them > to check it out. IOW, this seems not to be a known problem with a known > solution. >> The driver's-side mirror on our '02 300M is behaving strangely: when I >> shift into reverse, the mirror tilts down waaaay more than it used to >> -- down so far as to be pretty much useless -- and, when the shifter >> is not in reverse, does not always point in the same place each time >> the same set of adjustments is invoked, either with the remote or by >> pressing the button. >> >> Any ideas? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300M AT stuck in second gear | D & J Bergevin | Chrysler | 1 | October 31st 04 03:33 PM |
2002 300M Exterior Cleaning Question | [email protected] | Chrysler | 8 | October 25th 04 01:25 AM |
300M Club has a new forum home | Bill Putney | Chrysler | 0 | October 24th 04 04:44 AM |