If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Extremely High Idle on 93 SL2
I have a 1993 SL2 which I bought new and now has 217K miles on it. It
is now idling at very high speeds under some conditions. When the engine is warm (or hot) and the vehicle is moving, the engine will race up to 3000 RPM when the clutch pedal is depressed. When the vihicle comes to a complete stop, the engine slows to about 900 RPM. I have replaced the engine coolant temperature sensor (twice). I have tested the current sensor with an ohmeter and it seems to be fuctioning correctly. The connector is also new ($40 at the dealer for a $2 part!). I cleaned the throttle body and replaced the Idle Air Controller. I have also tested the Throttle Position Sensor with a voltmeter and it seems to be functioning correctly. If I drive until the engine is warm, stop the car's motion, wait for the engine to slow down, and remove the connector from the IAC, the engine does not race. This leads me to believe the controller is telling the IAC to draw it's pintle back. My conclusion is that I have a sensor problem. The fact that disabling the IAC eliminates the problem would seem to rule out a vacuum leak or a malfunctioning EGR valve. I may be wrong. (If I had the answer, I wouldn't be asking!) What other sensors besides the coolant sensor and throttle position sensor are used to determine idle speed. (Since the idle speed drops when the vehicle stops moving, I suspect the Vehicle Speed Sensor is working correctly). Thanks for your help. Terry |
Ads |
#2
|
|||
|
|||
Extremely High Idle on 93 SL2
You've done all this work and replaced a bunch of stuff, but have you read
the codes from the PCM to see if it indicates what is wrong? Autozone will do this for free, or you can do it yourself with a paperclip with the instructions he http://www.differentracing.com/tech_articles/index.html Refer to the OBD1 diagnostic code section. I would suspect your IAC valve because it controls the idle. But read those codes first to see if the PCM indicates anything else. Lane [ lane (at) evilplastic.com ] --- Visit my Saturn Car Audio and Performance Page at http://www.evilplastic.com "Son_Worshipper" > wrote in message oups.com... >I have a 1993 SL2 which I bought new and now has 217K miles on it. It > is now idling at very high speeds under some conditions. When the > engine is warm (or hot) and the vehicle is moving, the engine will race > up to 3000 RPM when the clutch pedal is depressed. When the vihicle > comes to a complete stop, the engine slows to about 900 RPM. I have > replaced the engine coolant temperature sensor (twice). I have tested > the current sensor with an ohmeter and it seems to be fuctioning > correctly. The connector is also new ($40 at the dealer for a $2 > part!). I cleaned the throttle body and replaced the Idle Air > Controller. I have also tested the Throttle Position Sensor with a > voltmeter and it seems to be functioning correctly. If I drive until > the engine is warm, stop the car's motion, wait for the engine to slow > down, and remove the connector from the IAC, the engine does not race. > This leads me to believe the controller is telling the IAC to draw it's > pintle back. My conclusion is that I have a sensor problem. The fact > that disabling the IAC eliminates the problem would seem to rule out a > vacuum leak or a malfunctioning EGR valve. I may be wrong. (If I had > the answer, I wouldn't be asking!) What other sensors besides the > coolant sensor and throttle position sensor are used to determine idle > speed. (Since the idle speed drops when the vehicle stops moving, I > suspect the Vehicle Speed Sensor is working correctly). Thanks for > your help. Terry > |
#3
|
|||
|
|||
Extremely High Idle on 93 SL2
|
#5
|
|||
|
|||
Extremely High Idle on 93 SL2
BläBlä wrote: > In article .com>, > says... > > I have a 1993 SL2 which I bought new and now has 217K miles on it. It > > is now idling at very high speeds under some conditions. When the > > engine is warm (or hot) and the vehicle is moving, the engine will race > > up to 3000 RPM when the clutch pedal is depressed. When the vihicle > > comes to a complete stop, the engine slows to about 900 RPM. I have > > replaced the engine coolant temperature sensor (twice). I have tested > > the current sensor with an ohmeter and it seems to be fuctioning > > correctly. > > It sounds like you know more than the average person that comes through > here but just to make sure you do know your 93 has "two" ECT sensors > right? One for the dash gage and one for the ECM. The one to the ECM > would be the important one. > > > The connector is also new ($40 at the dealer for a $2 > > part!). I cleaned the throttle body and replaced the Idle Air > > Controller. I have also tested the Throttle Position Sensor with a > > voltmeter and it seems to be functioning correctly. If I drive until > > the engine is warm, stop the car's motion, wait for the engine to slow > > down, and remove the connector from the IAC, the engine does not race. > > This leads me to believe the controller is telling the IAC to draw it's > > pintle back. My conclusion is that I have a sensor problem. The fact > > that disabling the IAC eliminates the problem would seem to rule out a > > vacuum leak or a malfunctioning EGR valve. I may be wrong. (If I had > > the answer, I wouldn't be asking!) What other sensors besides the > > coolant sensor and throttle position sensor are used to determine idle > > speed. (Since the idle speed drops when the vehicle stops moving, I > > suspect the Vehicle Speed Sensor is working correctly). Thanks for > > your help. Terry > > The speed sensors wont affect idle. Have you cleaned/checked the EGR > valve? In my previous reply, I forgot to respond to the part about 2 ECTs. The temp gage in the instrument cluster has been working correctly (at least it appears to) all along. The ECT I replaced was the one with 2 leads on it. I haven't messed with the single lead one above it. Thanks again. Terry |
#6
|
|||
|
|||
Extremely High Idle on 93 SL2
I caved in and took the car to my mechanic. He has been able to solve
every problem on every car I have taken to him - until now. He saw no codes to indicate why the idle is so high (up to 3000 RPM with clutch pedal depressed). All the sensors appear to be functioning correctly. The IAC reports being where it is commanded to be. He tells me that given enough time at ($1 per minute) he can find and fix the problem. His inclination is a problem in the Powertrain Control Module. Any thought on this. Also, if this is the route to go, how do I get the right module. I see some on Ebay where the seller says the numbers must match. Is this true or do the two cars just have to have the same engine, transmission, and perhaps some other items in common (for example ABS vs no ABS). Since this is a rather long thread, here is what has been done so far - 1) IAC replaced; 2) TPS checked and found good; 3) ECTS and connector replaced; 4) O2 sensor checked and found good; 5) throttle body removed and thorougly cleaned with throttle body cleaner and tooth brush; 6) PCV valve and hose replaced (hose was brittle); 7) Powertrain control module removed and replaced (having been in the computer industry, I have seen a lot of problems cured by removing and reseating connectors); 8) Vehicle Speed Sensor checked and found good; 9) EGR valve replaced. I am pulling my hair out. Any ideas besides changing out the PCM? Is it worthwhile ohming out the sensor leads? Last clue (for what it is worth) - if I warm the engine up, bring the car to a stop and wait for the engine speed to drop to 800-900 RPM and remove the IAC connector, the idle speed stays low on a test drive under conditions that would normally cause the problem leading me to believe the high idle speed is due to the computer commanding the IAC to open the pintle valve. Thanks! Terry |
#7
|
|||
|
|||
Extremely High Idle on 93 SL2
Given what has already been replaced, I have two additional thoughts on
possible causes of high idle: a defective Coolant Temperature Sensor (CTS) or a possible vacuum hose or intake manifold leak. Bob "Son_Worshipper" > wrote in message oups.com... >I caved in and took the car to my mechanic. He has been able to solve > every problem on every car I have taken to him - until now. He saw no > codes to indicate why the idle is so high (up to 3000 RPM with clutch > pedal depressed). All the sensors appear to be functioning correctly. > The IAC reports being where it is commanded to be. He tells me that > given enough time at ($1 per minute) he can find and fix the problem. > His inclination is a problem in the Powertrain Control Module. Any > thought on this. Also, if this is the route to go, how do I get the > right module. I see some on Ebay where the seller says the numbers > must match. Is this true or do the two cars just have to have the same > engine, transmission, and perhaps some other items in common (for > example ABS vs no ABS). Since this is a rather long thread, here is > what has been done so far - 1) IAC replaced; 2) TPS checked and found > good; 3) ECTS and connector replaced; 4) O2 sensor checked and found > good; 5) throttle body removed and thorougly cleaned with throttle body > cleaner and tooth brush; 6) PCV valve and hose replaced (hose was > brittle); 7) Powertrain control module removed and replaced (having > been in the computer industry, I have seen a lot of problems cured by > removing and reseating connectors); 8) Vehicle Speed Sensor checked and > found good; 9) EGR valve replaced. I am pulling my hair out. Any > ideas besides changing out the PCM? Is it worthwhile ohming out the > sensor leads? Last clue (for what it is worth) - if I warm the engine > up, bring the car to a stop and wait for the engine speed to drop to > 800-900 RPM and remove the IAC connector, the idle speed stays low on a > test drive under conditions that would normally cause the problem > leading me to believe the high idle speed is due to the computer > commanding the IAC to open the pintle valve. > > Thanks! > > Terry > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
95 Monte Carlo very high idle speed 4000 rpm's | [email protected] | Technology | 0 | February 23rd 05 03:35 AM |
intermittent high idle 98 SOHC | sehaare | Ford Explorer | 0 | December 8th 04 02:52 PM |
Cold Idle high | Oliver Gunnell | Audi | 5 | November 5th 04 02:14 AM |
High Idle | j2power | Mazda | 0 | November 3rd 04 06:48 AM |
High idle speeds | jdoe | Saturn | 4 | August 19th 04 04:10 PM |