If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Struggling with Outer Tie Rod Ends
Loosened the jam nut, separated the tie rod end from the steering
knuckle, but cannot get the tie rod end to rotate off the tie rod. It's frozen on. Any suggetions? |
Ads |
#2
|
|||
|
|||
Struggling with Outer Tie Rod Ends
Same problem with my PT Cruiser. I had to take it in to a shop where they
used a torch to heat the part up to white hot and then it would slowly turn off with some force. We then cleaned the bolt with a cutter and installed a new quality part. Took about 40 min. The crap OEM part exposed the part to moisture/salt etc. |
#3
|
|||
|
|||
Struggling with Outer Tie Rod Ends
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
inner & outer tie rod ends bent | MTED | Technology | 12 | July 31st 08 05:04 PM |
Tie-rod ends | PJ | Corvette | 0 | March 23rd 07 11:12 PM |
Tie rod ends | DanFXR | Jeep | 6 | November 14th 05 12:25 AM |
TIE ROD ENDS | jc | Chrysler | 2 | December 19th 04 01:41 PM |
struggling with brakes... | bug '59 | VW air cooled | 7 | October 26th 04 07:18 PM |