|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 20th 04, 03:25 PM
|
|||
|
|||
high idle speed revisited
Ran diagnostics a couple times on it and I get a strange code. Reads "PCM
system ram performance" this is followed by Idle speed too high or idle speed too low or both. Ideas? I will be looking at the connections to and from the control module but perhaps someone has seen this before on these little buggers. Larry 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
| need help with idle speed motor | jzz30 | Dodge | 0 | September 23rd 04 06:01 AM |
Linear Mode
