If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ActLab ForceRS paddles/rFactor 1150 stability?
So I'm super excited to try the new rFactor and mods, and one of my AL
ForceRS paddles breaks! I don't see any spares available through ActLabs - anyone got a source or dead wheel they want to sell? I'd snap up a LogiG25 if they were out. Also - has anyone seen 1150 of rFactor to be *much* less stable than previous versions? I get random CTDs all over the place, even when sitting in the menus. I've tried the obvious stuff (disabled the menu animations and music). I'm still running an un-modded reinstall - I thought it was OK when I let the AI take the F1 BMW around Toban for a few hours, but I still get totally random crashes at other times. No error message, just straight CTD. Thanks for any help, Kendt System specs - Opteron (perfectly stable)-2gb RAM-6800Ultra w/91.31 drivers I may crank it down, but it passes every stress-test as configured. |
Ads |
#3
|
|||
|
|||
ActLab ForceRS paddles/rFactor 1150 stability?
Bob Simpson wrote: > You can use any of the many buttons on the front of the wheel that you > like to change gears, of course. > > I just so happens that I broke one of the paddles on my Act-Labs Force > RS and got a replacement set. Contact me at > and depending on which one it is, > we might be able to work something out. (remove SPAMLESS btw). I'm > surprised that they don't offer this as a spare part since it's pretty > flimsy and likely to break. > > Bob Simpson > Thanks - you are a thoroughly helpful bloke . I think I'm covered - I found someone with a spare set of paddles. My CTDs turned out to be my BIOS reseting the CPU voltage to default - not enough to crash alot of other things, but rFactor was just taxing enough for me to finally notice. A 1.8Ghz Opteron @ 2.7Ghz needs a little extra juice (only 0.05V actually) Thanks! Kendt |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Electronic Stability Control, cross-referenced to NCAP safety ratings | John Bartley | Driving | 0 | January 2nd 06 08:09 PM |
"Al Qaeda" does not exist | Awake | BMW | 64 | March 10th 05 11:25 AM |
BMW series 5 disables Dynamic Stability Control and ABS | [email protected] | BMW | 6 | December 1st 04 06:02 PM |
Stability control: What do you think? | [email protected] | Chrysler | 14 | November 11th 04 04:34 AM |