![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
1988 CRX DX M/T. And some symptoms you might need to know if you read
far enough into this. New batt and alt. I do pizza driving at night, so consider. Full batt will run down, dash lights dim, headlights, etc at idle. You know the drill. NO parasitic draw (tested simple way and in series w/ batt). Accelerate and lights all come back up almost like the flip of a switch. Problem has become more and more persistent frequent. Early on before new alt and batt, prob might show up for a few hours and disappear for 2 weeks. Or might be obnoxious off/onn for two days and disappear for 2 weeks. Car might get better/charge left idling. Might not. Idiot light OK. Idiot light not On. I'm knind of lost. Bored or interested? read on. Where should I go from here? Also have had TC's for ELD 4-5 months ago...not one since. Also have had code for TP sensor. No other mods or tinkering that might have caused prob. Car came to me this way. I did batt and alt for sure fix :-) First off. I opened the ECU removing the four screws. Looking in I see the hold down screws for the board. Now, nearby are some LARGE soldered spots. Size-wise these "soldered lumps" look like what a soldered-over screw head would look like. Not saying they are screws, but the size and elevation/thickness is similar. Not your typical board size solder. These solders appear to have a ring/crack near the base where the solder intersects the board. Anyone else see this? I can't tell if they are actual cracks or not. I arrive here because I am having a charging prob. New battery (like I just bought it and put it in "new" b'cause I think the problem trashed the last "new" one from only 6-9 months ago.) New alternator about 6 months ago too. Am tracking through the Helms trying to find culprit other than an open circuit/cracked wire (pain in the butt) via the troubleshoot schematics. One helpful question I need answered: If procedure says check for "battery voltage" under certain conditions. I assume it means the test should provide batt voltage as the battery reads at the same instance NOT a standardized 12.5 or 14, etc? Am i correct? So I (think) I have gotten it down to the ECU or the ELD. Answer to the battery V question will clarify where I stand. In ECU case I am stuck at hooking the "test harness". Obviously don't have and don't know how to proceed. Please, please give me some pointers, gang. Much obliged. Kevin |
Ads |
#2
|
|||
|
|||
![]()
"Meathead" > wrote in message
... > 1988 CRX DX M/T. And some symptoms you might need to know if you read > far enough into this. New batt and alt. <...> > One helpful question I need answered: If procedure says check for > "battery voltage" under certain conditions. I assume it means the > test should provide batt voltage as the battery reads at the same > instance NOT a standardized 12.5 or 14, etc? Am i correct? > > So I (think) I have gotten it down to the ECU or the ELD. Answer to > the battery V question will clarify where I stand. In ECU case I am > stuck at hooking the "test harness". Obviously don't have and don't > know how to proceed. > Please, please give me some pointers, gang. Much obliged. > > Kevin I don't understand what your battery voltage is. Please elucidate. -- Graham W. www.gcw.org.uk Homebuilt Computer cooling. DIY projects Wimborne. www.wessex-astro.org.uk Society website, meetings, Dorset UK. location maps and future programs. |
#3
|
|||
|
|||
![]()
Meathead wrote:
> 1988 CRX DX M/T. And some symptoms you might need to know if you read > far enough into this. New batt and alt. I do pizza driving at night, > so consider. Full batt will run down, dash lights dim, headlights, > etc at idle. You know the drill. NO parasitic draw (tested simple > way and in series w/ batt). Accelerate and lights all come back up > almost like the flip of a switch. Problem has become more and more > persistent frequent. Early on before new alt and batt, prob might > show up for a few hours and disappear for 2 weeks. Or might be > obnoxious off/onn for two days and disappear for 2 weeks. Car might > get better/charge left idling. Might not. Idiot light OK. Idiot > light not On. I'm knind of lost. Bored or interested? read on. > Where should I go from here? Also have had TC's for ELD 4-5 months > ago...not one since. Also have had code for TP sensor. No other mods > or tinkering that might have caused prob. Car came to me this way. I > did batt and alt for sure fix :-) > > First off. I opened the ECU removing the four screws. Looking in I > see the hold down screws for the board. Now, nearby are some LARGE > soldered spots. Size-wise these "soldered lumps" look like what a > soldered-over screw head would look like. Not saying they are screws, > but the size and elevation/thickness is similar. Not your typical > board size solder. These solders appear to have a ring/crack near the > base where the solder intersects the board. Anyone else see this? I > can't tell if they are actual cracks or not. > > I arrive here because I am having a charging prob. New battery (like > I just bought it and put it in "new" b'cause I think the problem > trashed the last "new" one from only 6-9 months ago.) New alternator > about 6 months ago too. Am tracking through the Helms trying to find > culprit other than an open circuit/cracked wire (pain in the butt) via > the troubleshoot schematics. > > One helpful question I need answered: If procedure says check for > "battery voltage" under certain conditions. I assume it means the > test should provide batt voltage as the battery reads at the same > instance NOT a standardized 12.5 or 14, etc? Am i correct? > > So I (think) I have gotten it down to the ECU or the ELD. Answer to > the battery V question will clarify where I stand. In ECU case I am > stuck at hooking the "test harness". Obviously don't have and don't > know how to proceed. > Please, please give me some pointers, gang. Much obliged. > > Kevin 1. ecu is always the /last/ suspect, not the first. do /not/ mess with it unless you have a definite diagnosis. 2. if the battery is not charging and the battery is guaranteed good, you have a charging circuit problem. suggest getting the alternator tested. cheapo rebuilds are dreadful component quality and it's easily possible you have a dud. once you eliminate problems with the charging circuit, by far the most likely cause, check for draw by going through the small fuses in the fuse box and testing for current drain on each circuit. eld problem will likely disappear along with the charging circuit problem since the eld is solid state and most unlikely to fail. general note on error codes - reset and see if it comes back. random error codes when you have a known electrical problem are not reliable. |
#4
|
|||
|
|||
![]() Thanks Beamer. If I may thin it out a bit and restate...here's the simple version of the original post: Got car. All seems fine for weeks. Notice weak headlights/dash lights one night at idle while parked (pizza delivery). RPMs up = charging/lights brighten. Problem goes away same night...all normal. No problem 2 weeks then go out to dead batt in morning. Buy new battery. A-OK for a week...problem back one night...goes away same night. Repeat at random intervals for varying amounts of time from 15 minutes to 2 hours. Replace alternator. A-OK for 10 days-2 weeks. Problem back "seemingly" at random but more and more frequently and longer lasting too. One night driving at 45mph so little juice that stereo powers off and on and rpm's don't help. Check parasitic draw the simple way w/ batt ground off and also in series w/ batt. Test light does not light (tested many times through this whole ordeal). Have battery tested. Battery is toast. Replace battery. And here I am today. Car not driven since and sitting w/ fresh battery. Have gone through ELD troubleshoot/test. Appears OK. Now going through charging/alt circuit test and don't know how to proceed as I don't have the test harness to attach to the ECU. How to continue??? And final question Helms test procedures. Some troubleshoots say "is voltage 'X'?" While other parts say "is there battery voltage" at this terminal/connector. I assume "is there batt voltage?" means the same voltage reading that I would get if I took a reading on the battery at the same time under the same conditions...NOT just any ole voltage, right? So, if I can get throught the test harness part I should know something. If that tests out OK, am I just looking for a damn grounded wire or broken wire? Should prove fun. Help if you can. Thank you kindly. Kevin |
#5
|
|||
|
|||
![]()
Meatman wrote:
> Thanks Beamer. If I may thin it out a bit and restate...here's the > simple version of the original post: > Got car. All seems fine for weeks. Notice weak headlights/dash > lights one night at idle while parked (pizza delivery). RPMs up = > charging/lights brighten. Problem goes away same night...all normal. > No problem 2 weeks then go out to dead batt in morning. Buy new > battery. A-OK for a week...problem back one night...goes away same > night. Repeat at random intervals for varying amounts of time from 15 > minutes to 2 hours. Replace alternator. A-OK for 10 days-2 weeks. > Problem back "seemingly" at random but more and more frequently and > longer lasting too. One night driving at 45mph so little juice that > stereo powers off and on and rpm's don't help. Check parasitic draw > the simple way w/ batt ground off and also in series w/ batt. Test > light does not light (tested many times through this whole ordeal). > Have battery tested. Battery is toast. Replace battery. And here I > am today. Car not driven since and sitting w/ fresh battery. Have > gone through ELD troubleshoot/test. Appears OK. Now going through > charging/alt circuit test and don't know how to proceed as I don't > have the test harness to attach to the ECU. How to continue??? it's very unlikely it's ecu or eld. i'd therefore spend my time hunting down other electrical problems. > > And final question Helms test procedures. Some troubleshoots say > "is voltage 'X'?" While other parts say "is there battery voltage" at > this terminal/connector. I assume "is there batt voltage?" means the > same voltage reading that I would get if I took a reading on the > battery at the same time under the same conditions...NOT just any ole > voltage, right? you're looking at transistorized electronics so you're going to get voltages different to battery. i'm rusty on this stuff, but iirc, you get 0.7V drop across a silicon junction, add that a couple of times, and you'll see variance. and many electronic circuits of this era run on 5V. > > So, if I can get throught the test harness part I should know > something. If that tests out OK, am I just looking for a damn > grounded wire or broken wire? definitely. poorly wired stereos are a favorite along with alarms and aftermarket lights. especially if you have "extra" wires running from battery terminals that are unfused. > Should prove fun. Help if you can. > Thank you kindly. > > Kevin sorry - this is a job for a meter, patience, and good old fashioned detective work. look for obvious wiring mess-ups. and bad earth connections. the test procedure assumes things are wired right, so while it's a good guide, you have to use some logic as well. don't be afraid to get a re-built alternator re-rested. seriously, the bad ones can be awful. lastly, unless you've eliminated all other options, assume the ecu and eld are ok. but that said, my local junkyard will get you replacements for both for less than $50, so it's relatively cheap to "test" with replacements. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
More cops looking for a charge... | Brent P[_1_] | Driving | 1 | November 24th 07 04:02 AM |
No charge, no speedo | Spdloader | Honda | 38 | July 7th 06 12:48 PM |
AC Compressors Won't Take Charge | [email protected] | Technology | 4 | June 3rd 06 12:06 AM |
AC Charge on '97 EB | Stephen M. Gluck | Ford Explorer | 6 | June 9th 05 03:13 AM |