If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#4
|
|||
|
|||
No, you don't need any jacks , nor do you need to take the wheels off.
If you look underneath the front of your truck, by the radiator, you'll see a round bar, about 1 1/2" diameter, bolted to the frame on either side with 2 U brackets. The bushings are in the bracket. You can see them. You just need to take out the 2 bolts holding each bracket in. The bar will drop giving you enough room to remove the bushing from the bracket. It has a slit in it so the bushing can be removed from the bar. Put some water resistant grease or lubricant on it and put it back in. Just a tip. Removing the bolts might be a pain with just a regular 3/8" drive ratchet set. It will come easier with a 1/2 " drive ratchet set to give you more torque. Good luck. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need advice: droning, humming noise from front (40 MPH) | Emily Steed | VW air cooled | 6 | April 7th 05 06:09 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
Noisey VUE | Scout | Saturn | 5 | January 16th 05 12:59 AM |
front end noise | kevin neault | Saturn | 7 | July 3rd 04 02:24 PM |