If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cirrus woes continued
1996 Cirrus 2.4l -
dash lights, speedo and tach quit working a couple of times, but came right back on. Quit again and engine started missing, then died. Started right back up- done it twice now.... --- most of you think it is the crank pos sensor, yet some suggested cam sensor. -- No codes in system, no check eng light -- |
Ads |
#2
|
|||
|
|||
2K Intrepid did same thing. Crank sensor was intermittent and codes
were not set. At my insistence, dealer looked at "pending" codes with scanner and found problem. Looking back (hindsight is always 20/20) engine would occasionally "stumble" at idle when in gear and stopped in traffic. Since crank sensor was replaced, "stumble" has not recurred. partsmore wrote: > 1996 Cirrus 2.4l - > dash lights, speedo and tach quit working a couple of times, > but came right back on. Quit again and engine started missing, then > died. > Started right back up- > done it twice now.... > --- > most of you think it is the crank pos sensor, yet some suggested cam > sensor. > -- > No codes in system, no check eng light > -- > > |
#3
|
|||
|
|||
2K Intrepid did same thing. Crank sensor was intermittent and codes
were not set. At my insistence, dealer looked at "pending" codes with scanner and found problem. Looking back (hindsight is always 20/20) engine would occasionally "stumble" at idle when in gear and stopped in traffic. Since crank sensor was replaced, "stumble" has not recurred. partsmore wrote: > 1996 Cirrus 2.4l - > dash lights, speedo and tach quit working a couple of times, > but came right back on. Quit again and engine started missing, then > died. > Started right back up- > done it twice now.... > --- > most of you think it is the crank pos sensor, yet some suggested cam > sensor. > -- > No codes in system, no check eng light > -- > > |
#4
|
|||
|
|||
Ok when you say dash lites are you refering to the warning lites???? or the
dash nites for driving at nite???? A crank sensor will cause the engine to cut off/quit and the warning lites to go crazy but will not effect the dash lites "partsmore" > wrote in message lkaboutautos.com... > 1996 Cirrus 2.4l - > dash lights, speedo and tach quit working a couple of times, > but came right back on. Quit again and engine started missing, then > died. > Started right back up- > done it twice now.... > --- > most of you think it is the crank pos sensor, yet some suggested cam > sensor. > -- > No codes in system, no check eng light > -- > > |
#5
|
|||
|
|||
Ok when you say dash lites are you refering to the warning lites???? or the
dash nites for driving at nite???? A crank sensor will cause the engine to cut off/quit and the warning lites to go crazy but will not effect the dash lites "partsmore" > wrote in message lkaboutautos.com... > 1996 Cirrus 2.4l - > dash lights, speedo and tach quit working a couple of times, > but came right back on. Quit again and engine started missing, then > died. > Started right back up- > done it twice now.... > --- > most of you think it is the crank pos sensor, yet some suggested cam > sensor. > -- > No codes in system, no check eng light > -- > > |
#6
|
|||
|
|||
The instrument cluster lites go out; the tach and the trip odometer quits.
Upon restart everythign workds fine. Happened twice in the last two days after operation of 1-2 miles/minutes - then runs fine! |
#7
|
|||
|
|||
The instrument cluster lites go out; the tach and the trip odometer quits.
Upon restart everythign workds fine. Happened twice in the last two days after operation of 1-2 miles/minutes - then runs fine! |
#8
|
|||
|
|||
I cant see how the crank/cam sensor is any way related to the Illumination
lites, i can see the tach going out but not the trip odometer, "partsmore" > wrote in message lkaboutautos.com... > The instrument cluster lites go out; the tach and the trip odometer quits. > Upon restart everythign workds fine. > Happened twice in the last two days after operation of 1-2 miles/minutes - > then runs fine! > |
#9
|
|||
|
|||
I cant see how the crank/cam sensor is any way related to the Illumination
lites, i can see the tach going out but not the trip odometer, "partsmore" > wrote in message lkaboutautos.com... > The instrument cluster lites go out; the tach and the trip odometer quits. > Upon restart everythign workds fine. > Happened twice in the last two days after operation of 1-2 miles/minutes - > then runs fine! > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
98 Chrysler Cirrus ABS question | Matt Whiting | Chrysler | 0 | November 5th 04 02:28 AM |
1999 Cirrus making grinding noise | Bill Putney | Chrysler | 4 | October 8th 04 04:29 PM |
95 cirrus dash | Jay | Dodge | 0 | May 5th 04 02:08 AM |