If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
UPDATE - was 93 YJ vibration problem
Thanks for the tips guys,,,,, turns out the best tip was from a guy at work:
His recommendation was to replace the u-joints on the drive shaft, even though they appear to be solid sometimes you'll get one bearing cap that goes bad and it is enough to set off vibration. Replaced both U-joints yesterday,,, vibration is gone today! And sure enough there was one bearing cap with half the needles chewed up. thanks again |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |
Nissan vibration | Peter Sheriff | Technology | 2 | February 15th 05 05:41 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |