If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Valve setting
"Joey Tribiani" > wrote in message news:... > > "Mike West" > wrote in message > ... >>I have a 66 bug with a 1776 cc engine. I know it has some sort of reground >> cam, bigger jugs and pistons and headers. What I don't know is what gap >> to >> set my valves at. Any suggestions? >> Thanks, Mike >> >> > > if you have alluminum pushrods stick to the stock 0.06....if you have > steel/chromoly pushrods(common in "highperformance" engines) i adjust mine > to a "loose zero"...that is, remove all the lash, but loose enough to > still spin the pushrod with your fingers.... > eeeeeekkkkkk...... that should read .006"..... fingers are not as fast as my brain...or out of time...hehe.. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Valve setting | Mike West | VW air cooled | 2 | June 9th 06 01:56 AM |
Research Qs on my 91 16V AT valve body....LONG and semi-Technical | One out of many daves | VW water cooled | 5 | May 3rd 05 04:31 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 2 | April 22nd 05 05:32 AM |
'94 Voyager - what is code 32 ???? | Greg Gall | Chrysler | 11 | April 16th 05 02:10 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |