If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
93 SL1 - Purge canister solenoid?
Service light comes on intermittantly - generally only after the car has got up to temp, and usually only when I slow down or come to a stop. Scaned the PCM - codes 26, 32 came up. I replaced the EGR solenoid and the PCV valve (EGR valve was done less than 6 mo ago). Cleared the codes.....and guess what the service light still flashes same as before. This time its a straight code 26. Anyone have any ideas? Please help Some say that its the canister purge solenoid that probably the cause - I have no idea where it is - how do I find it? Is it as easy to do as the EGR solenoid? Thanks, Ian |
Ads |
#2
|
|||
|
|||
On Thu, 05 Aug 2004 04:48:41 -0400, Iceman35 wrote:
>[...] > Some say that its the canister purge solenoid that probably the cause - > I have no idea where it is - how do I find it? Is it as easy to do as > the EGR solenoid? Unfortunately no. The EGR valve and solenoid are in plain sight, and trivial to change. The Purge Canister Solenoid is hard to get to. I had to use a mirror to even see it. If you have small hands and your arm is made of rubber, then you can get to it fairly easily. Otherwise, you have to remove something (the starter?). Anyway, if you look just behind and left of the EGR valve, then stick your had straight down and then to the left behind the engine, you can grab it. Tell us if you get it done, because I have a new canister solenoid that I've yet to install because it's too damn hard, so any encouraging word will help me. Since the part is so cheap, you might as well replace it. Meph |
#3
|
|||
|
|||
Ihad same problem, it was egr selonoid. very easy to replace, it is nears
the throtle body ! "Iceman35" > a écrit dans le message de lkaboutautos.com... > > Service light comes on intermittantly - generally only after the car has > got up to temp, and usually only when I slow down or come to a stop. > Scaned the PCM - codes 26, 32 came up. > I replaced the EGR solenoid and the PCV valve (EGR valve was done less > than 6 mo ago). Cleared the codes.....and guess what the service light > still flashes same as before. > This time its a straight code 26. > Anyone have any ideas? Please help > Some say that its the canister purge solenoid that probably the cause - I > have no idea where it is - how do I find it? > Is it as easy to do as the EGR solenoid? > > Thanks, > Ian > |
#4
|
|||
|
|||
"Iceman35" > wrote in message alkaboutautos.com>...
> OK I've done it! > I was a bit of a bitch - I went at it from the right side. I had to take > off the intake bracket, and pull off the fuel Hard lines (hence the EGR > valve) to get enough speace for my hand to fit. Well with some liquid > wrench, a 10mm rachet, a flashlight and a lot of cursing its off. On my wife's 92 SL1 I got to it from underneath. I had to use a mirror to see it at all, and after finding it it wasn't too bad to replace it. Tim. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
74 Cutlass with starting problem | Amanda Robin | Antique cars | 12 | October 26th 04 02:46 AM |
95 Caravan EGR valve solenoid | John Boy | Dodge | 2 | July 21st 04 01:52 PM |
pressure control solenoid | Larry C | Saturn | 0 | July 5th 04 10:54 PM |