|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 10th 06, 03:32 PM
posted to rec.autos.makers.chrysler
|
|||
|
|||
Sebring 2001
The drivers auto door lock stopped working. I checked the fuses and replaced
the button but it still doesn't work. The actuator is good because it opens and closes when the passenger button is pressed. Any ideas? Thanks. 
|
| Ads |
|
#2
August 11th 06, 11:24 AM
posted to rec.autos.makers.chrysler
|
|||
|
|||
|
Sebring 2001
You say you replaced the button does that mean you replaced the master
switch? If so and it didnt fix it you can start by checking for continuity at pin 4 WT/DG wire from the switch at the drivers side to pin 15 (brown Connector) of the BCM. If this wire is good you Glenn Beasley Chrysler Tech
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Buying gasoline Sebring 2001 | Hennie | Chrysler | 4 | June 18th 06 03:46 AM |
| 1999 Intrepid v.s. 2001 Sebring | [email protected] | Chrysler | 4 | May 6th 06 12:24 AM |
| 2001 Sebring Temp gauge fluctuations | casey_rf | Chrysler | 3 | October 19th 05 08:58 AM |
| Flasher ? for 2001 up/Led Taillights | Intergate | Jeep | 7 | February 15th 05 07:00 PM |
| 2001 Sebring Sedan 2.7 Engine/Tranny Whistle ?? | philu | Chrysler | 4 | February 4th 05 03:28 AM |
Linear Mode
