If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
91 SI oil eater after rebuild....?
On Sat, 13 Aug 2005 11:37:20 -0400, RayGun >
wrote: >Hello All >Just rebuilt my daughters Civic last winter. Broken, and bent valve. >Did the rings, and all the gaskets, valves seals,...the whole enchelada. >Break-in period was easy, over 2500 kms. >A few months later, it started to eat more and more oil, now is up to >a litre a week. Clean engine bay, no drips under or over.... >Anyone had experience similar to this...and what were the results. >Appreciate any input >Thanx >Ray you replaced the rings, how was piston clearance? sounds like a sloppy rebuild with no boring and oversized pistons and rings, a brand new top end will blow oil on a factory bottom end. Chip |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water Pump Rebuild Kit for 289 | Fred of AZ | Ford Mustang | 5 | June 28th 05 11:49 PM |
Carb Rebuild and Air Cleaner ? | Iowa883 | VW air cooled | 8 | February 4th 05 06:18 PM |
FA: Mopar Engine Rebuild and Charger Restoration Books | _p_phunk | Dodge | 2 | January 1st 05 07:00 PM |
Rebuild Audi Blower motor? | Kevin | Audi | 2 | August 10th 04 11:34 PM |